SCANIA industrial engines DC09 074A. 202 kW (275 hp) EU Stage II, China Stage II and Russia Stage I The industrial engines from Scania are based on a robust design with a strength optimised cylinder block containing wet cylinder liners that can easily be exchanged. Individual cylinder heads with 4 valves per cylinder promotes repairability and fuel economy.   The engine is equipped with a Scania developed Engine Management System, EMS, in order to ensure the control of all aspects related to engine performance. The injection system is based on electronically controlled unit injectors that gives low exhaust emissions with good fuel economy and a high torque. The engine can be fitted with many accessories such as air cleaners, PTOs and flywheels in order to suit a variety of installations. Engine speed (rpm) Rating Gross power (kW) ICFN 1200 1500 1800 2100 195 202 202 202 Gross power (hp) ICFN 265 275 275 275 Gross torque (Nm) ICFN 1552 1286 1072 919 Spec fuel consumption. Full load (g/kWh) 198 195 207 226 Spec fuel consumption. 3/4 load (g/kWh) 197 198 210 237 Spec fuel consumption. 1/2 load (g/kWh) 202 208 222 254 74 74 80 91 Heat rejection to coolant (kW) Standard equipment • Scania Engine Management System, EMS • Unit injectors, PDE • Turbocharger • Fuel filter and extra pre-filter with water separator • Oil filter, full flow • Centrifugal oil cleaner • Oil cooler, integrated in block • Oil filler, in valve cover • Deep front oil sump • Oil dipstick, in block • Magnetic drain plug for oil draining • Starter, 1-pole 6.0 kW • Alternator, 1-pole 100A • Flywheel, for use with friction clutch • Silumin flywheel housing, SAE 1 flange • Front mounted engine brackets • Open crankcase ventilation • Operator’s manual Optional equipment • Cooling package • Puller and pusher fans • Fan ring with sealing • Hydraulic pump • Air compressor • AC compressor • Side-mounted PTO • Front-mounted PTO • Exhaust connections • Electrical base system • Control and instrument panels • Accelerator position sensor • Engine heater • Flywheels: SAE11.5”, SAE14”, DANA15/16”, DANA17” flexplate, ZF WG260 • Stiff rubber engine suspension • Air cleaner • Closed crankcase ventilation • Studs in flywheel housing • External thermostat for extra oil cooler • Low coolant level reaction • Variable idle speed setting • Low oil sump • Oil level sensor ICFN – Continous service: Rated output available 1/1 h. Unlimited h/year service time at a load factor of 100% This specification may be revised without notice.