Automation / Micro Hollow Shaft Encoder - Hollow Bore: Mechanical Specifications Electrical Specifications Housing: Aluminum / Brass Cap: Aluminum Hollow Shaft: Brass Encoder: ~ 12 gr (0,53 oz) Cable: 50 gr / meter (1,76 oz / meter) Bearing Life: > 1,9 x 1010 revolutions at rated load Bearing Pre-Load: Shaft Speed: Starting Torque: Mass Moment of Inertia: Hollow Shaft Loads: Supply Voltage: Output Voltage: Output Current: 20 mA max. load per output channel Frequency Response: Output Format: Two channel (A, B) quadrature with Index (Z) and optional complementary (A-, B-, Z-) outputs Phase Sense: A leads B clockwise (CW) from the mounting end of the encoder Environmental Specifications Operating Temp.: Gated with Channels A and B high Storage Temp.: Enclosure Rating: Electrical Protection: Noise Immunity: Reverse polarity and output short circuit protected Tested to EN61000-6-2 : 2005 (industrial environments) Electromagnetic compatibility (EMC) and EN 61000-6-3 : 2007 (residential, commercial, and lightindustrial environments) for Electromagnetic compatibility (EMC) Connection Options Cable: 8 leads (0,05 mm2, 30 AWG) twisted pairs; shielded Flat Cable: 10 lead flat cable with IDC connector = It is recommended, not to combine max. Value for all 3 parameters

Type SCH16G Output waveform Disk Resolutions (pulses per revolution) Other options on request Pulses per revolution, min. 1 – max. 5.000 Channel tolerance Phase difference tolerance Z channel tolerance Mechanical Dimensions Tolerances according to ISO 2768 f

Type SCH16G Tolerances according to ISO 2768 f Output Terminations Standard Cable Flat Cable w/ IDC Connector Differential Output* Differential Output Inverted Output** Wire Color Pink Gray Green Yellow White Brown Red Blue * Hewlett Packard (HP) compatible ** ID # required for ordering IP 50 rating CE mark not available 0,5 m, 1 m, or 2 m cable length only

Type SCH16G Ordering Code Hollow Shaft Hollow Shaft Cable Length Connector Spring Cable Takeout Coupling Standard Cable Differential Inverted (Flat cable option only) Standard is 1 meter Specify length Flat Cable w/ IDC 0,5 meter Side (radial) Back (axial) Flat cable w/ IDC connector* Other options on request: Please contact Scancon A/S See Accessories for drawings Other options on request: Please contact Scancon A/S