5-Phase Stepping Driver DC input ■ Applications Medical equipment, semiconductor manufacturing equipment, measuring instruments, analyzers, and electron microscopes High Torque Easy Replacement The high-power model achieves approximately 1.5 times higher or more torque at high speeds than our current model,(1) reducing the cycle time of your equipment and increasing productivity. The basic models have mounting and interface compatibility with the current model(2) for easy replacement. Equipment performance can be improved by simply replacing your current stepping driver with a new model, with your current motor unchanged. Low Vibration Motor vibration during operation has been reduced to one-third or less compared to the current model.(1) These drivers help make equipment motion smoother, improving the processing precision and reducing the noise. Various Useful Safety Functions • Using PC software, the high-power model offers fine settings of input/output signals, maintenance timing notifications, and current value selection optimized for customer equipment. • Overcurrents and wire breakage caused by pinched motor power cables can be detected and notified with an alarm and motors can be stopped safely. Abnormal power supply voltage and heat generation can be notified even before the alarm goes off, ensuring the safety of your system. Compact and Lightweight The high-power model is newly designed to achieve a 63% reduction in volume and 73% reduction in mass compared to our current model.(3) The basic model achieves a 7% reduction in volume and 39% reduction in mass while maintaining compatibility with the current model.(2) (1) Current model: 5-phase stepping driver (model: F5PAE140P100) combined with 60 mm sq. stepping motor (model: S□5601-□2□□) (2) Current model: 5-phase stepping driver (model: FS1D140P10) (3) Current model: 5-phase stepping driver (model: F5PAE140P100) SANMOTION F5 high-power model SANMOTION F5 basic model High torque, high performance Compatible with our current models Input voltage Input current Operating environment Installation category (Overvoltage category): I (CE), pollution level: 2 Operating ambient temperature Storage temperature Operating ambient humidity Storage humidity Operating altitude 1000 m or lower above sea level Vibration resistance 5 m/s2, at frequency of 10 to 55 Hz in each X, Y, and Z direction for 2 hours Shock resistance Basic specifications Basic specifications Protection class Dielectric strength 700 VDC for 1 minute (between power input terminal and chassis) Insulation resistance 10 MΩ min. at 500 VDC (between power input terminal and chassis) 60 g Function selections Functions Pulse input mode (1-/2-input mode), low vibration mode (on/off), automatic current limiting (on/off), step division mode (2-/5-phase mode), initial excitation phase (excitation origin/excitation phase of last power off), motor selection, operating current, step angle Protection functions Overcurrent protection, power supply voltage monitoring, overheat detection, motor wire breakage detection, command speed error, memory error, hardware error Power supply monitoring, alarm status monitoring PC-based functions Parameter customizatio

■ Compatible motors Driver and motor combination table Driver model Motor size SANMOTION F5 high-power model SANMOTION F5 basic model Dual shaft Single shaft Rated current 2.8 A/phase 0.75 A/phase SANMOTION F5 high-power model Model no.: F5PFD280P100 SANMOTION F5 basic model Model no.: F5PED140P100 The names of companies and/or their products specified in this document are the trade names, and/or trademarks and/or registered trademarks of such respective companies. San Ace, SANUPS, and SANMOTION are registered trademarks of SANYO DENKI CO., LTD. Specifications are subject to change without notice....