San Ace 120AD 9AD type
4Pages

{{requestButtons}}

Catalog excerpts

San Ace 120AD 9AD type - 1

ACDC Fan ■ Features High Static Pressure and High Airflow This fan delivers a maximum static pressure of 62 Pa and a maximum airflow of 2.35 m3/min.(1) Long Life The expected life has increased by 2.4 times compared with our current model.(2) Wide Operating Voltage Range This fan has an input voltage range of 100 to 240 VAC, supporting both 100 and 200 VAC systems. Low Noise and Energy Saving The PWM control enables the control of fan speed, contributing to lowering noise and improving energy efficiency of equipment. (1) For models 9AD1201P4H001 and 9AD1201H4002 (2) Current model: 120 × 120 × 25 mm San Ace 120 AC Fan (model: 109S085) at a frequency of 60 Hz. 120 × 120 × 25 mm ■ Specifications The models listed below have ribs and pulse sensors with PWM control function. For models without ribs, append "1" to the end of model numbers. PWM Operating Rated voltage Frequency Rated current Rated input Rated speed Max. airflow Max. static pressure duty cycle* voltage range [V] [Hz] [A] [W] [min-1] [m3/min] [CFM] [Pa] [inchH2O] [%] [V] Operating Expected temperature life [°C] [h] * PWM frequency is 25 kHz. Models without ratings for 0% PWM duty cycle have zero speed at 0%. When control terminal is open, speed is the same as at 0% duty cycle. The models listed below have ribs and no sensors. For models without ribs, append "1" to the end of model numbers. Operating Rated voltage Frequency Rated current Rated input voltage range [V] [Hz] [A] [W] [V] Note: Models with the following sensor specifications are also available as options: ■ Common Specifications ・・・・・・・・・・・・・・ □ Material ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ Frame: Plastic (Flammability: UL 94V-0), Impeller: Plastic (Flammability: UL 94V-0) ・・・・・・・・・・・・ □ Expected life ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ Refer to specifications (L10 life: 90% survival rate for continuous operation in free air at 60°C, rated voltage) Expected life at 40°C is for reference only. ・・・・・ □ Motor protection function・ ・ ・ ・ ・ ・ Locked rotor burnout protection ・・・・・・・・・ □ Dielectric strength ・ ・ ・ ・ ・ ・ ・ ・ ・ 50/60 Hz, 2500 VAC, for 1 second (between lead wire conductors and frame) 50/60 Hz, 1500 VAC, for 1 minute (between input lead wire (L,N) conductors and other lead wire conductors) ・・・・・・・・ □ Insulation resistance ・ ・ ・ ・ ・ ・ ・ ・ 10 MΩ min. at 500 VDC (between lead wire conductors and frame, between input lead wire (L,N) conductors and other lead wire conductors) ・・・・ □ Sound pressure level (SPL) ・ ・ ・ ・ ・ A-weighted sound pressure level (SPL) at 1 m away from the air inlet. ・・・・・・ □ Operating temperature ・ ・ ・ ・ ・ ・ ・ Refer to specifications (Non-condensing) ・・・・・・・・ □ Storage temperature ・ ・ ・ ・ ・ ・ ・ ・ -30 to +70°C (Non-condensing) ・・・・・・・・・・・・・ □ Lead wire ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ AC power input L: Orange N: Gray Sensor Yellow Control Brown GND Black (For models without sensors, there i

Open the catalog to page 1
San Ace 120AD 9AD type - 2

■ PWM Duty - Speed Characteristics Example (min-1) 4000-r Input voltage: 100 VAC 50/60 Hz 240 VAC 50/60 Hz PWM frequency: 25 kHz

Open the catalog to page 2
San Ace 120AD 9AD type - 3

120 × 120 × 25 mm ■ PWM Input Signal Example Input signal waveform VIH = 4.75 to 5.25 V VIL = 0 to 0.4 V VIL When the PWM control terminal is open, the fan speed is the same as the speed at 0% PWM duty cycle. ■ Example of Connection Schematic Inside of fan Isource Isink PWM input signal ■ Specifications for Pulse Sensors Output circuit: Open collector Inside of fan Pull-up voltage Photocoupler Pull-up resistor Sensor output Output waveform (Need pull-up resistor) In case of steady running (One revolution) T0 T1 VOH VOL 0V PWM duty cycle (%) = T ×100 PWM frequency 25 (kHz) = T Current source...

Open the catalog to page 3
San Ace 120AD 9AD type - 4

■ Dimensions (unit: mm) (Ribbed frame with pulse sensor with PWM control function) 4xø4.5±0.3 Mounting hole Power lead wire AWG 22 UL 11347 Other lead wire AWG 24 UL 1430 +30 300 0 Rotating direction Airflow direction ■ Reference Dimensions of Mounting Holes and Vent Opening (unit: mm) Inlet side, Outlet side ■ Options Finger guards Resin finger guards Resin filter kits Model no.: 109-1000F13 (13PPI), 109-1000F20 (20PPI) ●Please read the "Safety Precautions" on our website before using the product. ●The products shown in this catalog are subject to Japanese Export Control Law. Diversion...

Open the catalog to page 4

All SANYO DENKI America catalogs and technical brochures

  1. San Ace 40L

    4 Pages

  2. SANMOTION R 3E

    172 Pages

  3. SANMOTION T

    36 Pages

  4. SANMOTION F5

    128 Pages

  5. SANMOTION F2

    84 Pages

  6. SANMOTION C

    12 Pages

  7. DC Fan Catalog

    247 Pages

  8. San Ace 92W

    4 Pages

  9. San Ace B97

    2 Pages

  10. San Ace 40

    2 Pages

  11. San Ace 60T

    2 Pages

  12. Blower

    20 Pages

  13. ACDC Fan

    5 Pages

  14. SANMOTION R

    40 Pages

  15. Hybrid UPS

    8 Pages

Archived catalogs

  1. AC_San_Ace

    56 Pages

  2. DC_San_Ace

    332 Pages

  3. PD-D11A

    8 Pages