■ Until quite recently, we had started the measurement after unraveling the tangles of LINE side(RED) and GROUND side(BLACK) test leads. ■We have been changed the test probes to the breaker pin probe when measuring from ■When measuring the resistance of the circuit breaker, we had a pocket size Testers separately from the Insulation Resistance Tester. It was a hassle to carry both Testers. ■ We had a problem that the GROUND side(Black) test lead was too short inside of the distribution board. It was not enough length for the measurement. ■ For instance, in the past, we were measuring in the left hand with probe, and in the right hand with main unit. We needed to shift our gaze from the tip of the left hand with probe to the right hand with main unit display. ■The standard test probe was changed to the breaker pin type probe, and the breaker pin type probe is directly connected to the main unit. This will help your measurement more smoothly than ever before. ■ Both LINE side test lead and Ground side test lead are removable style, and they will arrow you to connect various Sanwa accessories or Aligator Clips. Use breaker pin type probe to the Ground side, no need to remove the terminal at the time of line voltage measurement. Use commercially available test leads to the LINE side, it helps your measurement at a high altitude. We have adopted High-durability nylon-woven copper material for the GROUND lead of 2m length, it will not break so easily even fine. AMeasuring the value from the top of the terminal cover with HG561

ASince every probe is removable style, A On the back side of the main unit, it will arrow you to connect various thre is a hook for the length adjustment Sanwa accessories ■We must carry many measuring instruments and tools during the electrical inspection, ■ Normally we work collaboratively, but suddenly we have to work for one person. It takes time to work with both hands are full. ■ We want to use nickel-metal hydride rechargeable batteries for the measuring instruments to reduce the total amount of garbage. ■We usually wait until the measured value is stabilized when we use Digital Meters....

■We improved the readability of the display. As an Analog Multitester, we use a LED at a glance. For instance, , if the result of PASS is more than 1 MO, you could recognize whether the green LED of 1 MO lights or not without looking at the values. Easy - to - read LCD with the fixed decimal point. As an Analog Multitester, Easy ~to ~ read LCD we use a LED at a glance. *Mh the fixed decimal point. AThe LED light embedded in the leading end of the main unit and the back light of the liquid crystal display illuminate at the same time, and the lighting lamp illuminates a place to be measured, and...

(- TEST VOLTAQE \ AWhen the circuit to be measured is in a hot-line condition^ 30 V ac/dc ), and under this condition, even if the TEST button gets pressed, the instrument will not generate any test voltage. Turn off the circuit to be measured, and then measure