LEAKAGE CLAMP METER This meter is useful for measuring leakage or load current on power lines and equipment instrument in the ranges of CAT. III environment. ●Cut current value of high frequency at mAACA LPF(Low Pass Filter) function ●MAX/MIN value hold, Data hold function ●Back light function ●Auto power save function SPECIFICATIONS ACmA ACA ACV DCV Resistance Operation method AC measuring method Sampling rate Display Range selection Auto power save Battery low warning Operating temperature / humidity Storage temperature / humidity Continuous use time Power consumption Safety standards Bandwidth Display Clamp diameter / Conductor size Battery Size / Mass Standard accessories included Double integration Average sensing 2 times / sec 6000(V/A) 9999(Ω) Auto Power save about 30 minutes after no operation Battery ( ) mark lights or flickers at approx. 2.2V or below 5℃40℃, below 80%RH(max) No condensation -10℃50℃, below 80%RH No condensation About 90 hours(when back light is not lighted) 33mW IEC61010-1 CAT.III 600V, IEC61010-2-032,IEC61010-031 40400Hz 6000(V/A), 9999(Ω) 35mm / 10 x 40mm LR03 x 2 206 x 83 x 38mm / 320 Test lead(TL-23a), Carrying case(C-DCM660), Instruction manual A battery for monitoring has been installed prior to shipment from the factory. It may be discharged before the expiration of the described battery life. This battery is used to check the functions and performance of the product.Specifications and external appearance of the product described above may be revised for modification without prior notice. Dempa Bldg, 4-4 Sotokanda 2-Chome, Chiyoda-Ku, Tokyo 101-0021 Japan Tel:+81-3-3251-0941 Fax:+81-3-3256-9740