GEAR PUMPS "PLC" SERIES - GROUP 2 Technical catalogues Via Emilia Ovest 1006 - 41100 Modena (Italy) Tel. 0039 059 387411 - Fax. 0039 059 387500 www.salami.it - [email protected]

Working conditions P2 = Intermittent operating pressure (1/3 of working time) P1 = Continuous operating pressure AGRICOLA gear pumps are available with displacements from 4.5 cm3/rev to 22.5 cm3/rev. AGRICOLA gear pumps and motors offer: • High volumetric efficiency by innovative design and accurate control of machining tolerances. • Axial compensation achieved by the use of floating bushes that allow high volumetric efficiency throughout the working pressure range. • DU bearings ensure high pressure capability. • 12 teeth integral gear and shaft. • Extruded alluminum body. • Cast-iron rear cover...

Features DRIVE SHAFT Radial and axial loads on the shafts must be avoided since they reduce the life of the unit. PUMP ROTATION DIRECTION VIEWED AT THE DRIVE SHAFT Clockwise rotation Anti - clockwise rotation HYDRAULIC PIPE LINE To ensure favorable suction conditions it is important to keep pressure drop in suction pipe line to a minimum value (see WORKING CONDITIONS). To calculte hydraulic pipe line size, the designer can use; as an approximate guide, the following fluid speed figures: From 1 to 2 m/sec on suction pipe line From 6 to 10 m/sec on pressure pipe line The lowest fluid speed values...

Features FILTRATION INDEX RECOMMENDED Working pressure Achieved with filter ßx =75 FIRE RESISTENT FLUID Type oil emulsion with 40% water Water glycol Phosphate esters COMMON FORMULAS LEGENDA Dp = Working pressure (bar) q = Displacement (cm3/rev) 3 For more information: WWW.SALAMI.IT

GEAR PUMPS ASSEMBLING DIMENSIONS - PERFORMANCE DATA For more information: WWW.SALAMI.IT

FLANGED PORTS For more information: WWW.SALAMI.IT

ORDERING CODES Clockwise rotation Anti-clockwise rotation CODES DESCRIPTION OF THE NEW PRODUCT IDENTIFICATION LABEL Product short description. Salami part number and progressive number of assembling. Mounth and year of made Rotation sense. For more information: WWW.SALAMI.IT

2PLC ROTATION CHANGING INSTRUCTIONS For more information: WWW.SALAMI.IT

2PLC ROTATION CHANGING INSTRUCTIONS For more information: WWW.SALAMI.IT

2PLC ROTATION CHANGING INSTRUCTIONS For more information: WWW.SALAMI.IT

GEAR PUMPS "PLC" SERIES - GROUP 2 Technical catalogues Via Emilia Ovest 1006 - 41100 Modena (Italy) Tel. 0039 059 387411 - Fax. 0039 059 387500 www.salami.it - [email protected]