Marine Product Catalog
7Pages

Marine Product Catalog SERVICING MILLIONS OF BOATS WORLDWIDE

05 Water Pressure Systems 52 MARINE PRODUCT CATALOG 02 Bilge Pumping Systems Electric Submersible Pumps 12 Bilge Pump Control & Panel Switches 14 General Purpose Pumps 16 Jabsco & Rule Accessories 18 Amazon Manual Diaphragm Pumps 20 Electric Diaphragm Pumps 22 Electric Flexible Impeller Pumps 24 Engine Driven, Electric Clutch Pumps 26 Engine Driven, Manual Clutch Pumps 28 Twist 'n' Lock Manual Toilets Lite Flush Toilets Electric Toilets & Kits Quiet Flush Electric Toilets Deluxe Flush Electric Toilets Automatic Pressure Controlled Pumps Accessories & Accumulator Tanks Washdown Pumps Diesel...

Contents MARINE PRODUCT CATALOG 11 Flexible Impeller Pumps 13 Service Parts (continued) Selection Guide PAR-Max Series & PAR-Mate Pumps PAR-Max 4.0 GPM Washdown Pump Pulley Driven Pumps Old 30XXX Series PAR-Max Pumps Upgrade to Jabsco Engine Cooling Pumps New 31XXX Series PAR-Max Pumps Cooling Pump Spares by Make of Engine Sensor Max™ VSD & Dual Max Pumps Amazon Manual Diaphragm Pumps Jabsco Manual Toilets 1998 to 2007 Jabsco Manual Toilets 2008 Onward Electric Conversion for Manual Toilets Electric Toilets 18590 Series Run-Dry Macerator Pump Replacement Bulb Guide Impeller Selection...

01 An Introduction to Pumps OVERVIEW OF PARTS Livewell/Baitwell Pumps Ballast Pump Freshwater Pumps Engine Cooling Bilge Pumps & Switches Bilge Blower

Shower Drain Pumps Toilet Systems

01 An Introduction to Pumps INTRODUCTION Flexible Impeller Pipe runs should always be kept as short and straight as possible. Plumbing should always be reinforced, non-collapsible hose of the recommended size. Electric pumps should always be installed in a dry, well-ventilated position as close to the liquid to be pumped as possible. Flexible impeller pumps must not be run dry. Bilge pumps and water pumps in particular should be fitted with a filter or strainer on the inlet plumbing to protect them from debris. These should be fastened to the boat structure to ensure their permanent...

Sliding Vane Electric pumps should always be installed in a dry, well-ventilated position as close as possible to the liquid to be pumped. Plumbing should always be reinforced, non-collapsible hose of the recommended size. Bilge pumps and water diaphragm bilge pumps in particular should always be fitted with a filter and strainer on the inlet plumbing to protect them from debris. These should be fastened to the boat structure to ensure their permanent location. Pumps must be installed with the overboard discharge well above the waterline (both static and heeled) to avoid water siphoning...