MCL-75-F
1Pages

MCL-75-F Ruland MCL-75-F, 75mm One-Piece Shaft Collar, Black Oxide Steel, Clamp Style, 103mm OD, 19mm Width Description Ruland MCL-75-F is a one-piece shaft collar with a 75mm bore, 103mm OD, and 19mm width. The clamp style design does not mar the shaft, is easy to remove, and is indefinitely adjustable. It is commonly used for guiding, spacing, stopping, mounting, and component alignment. Equipment manufacturers benefit from the tightly controlled face to bore perpendicularity (TIR of ≤ .05mm). Perpendicularity is critical for alignment when the shaft collar is used as a load bearing face, mechanical stop, or for mounting components such as gears or bearings. Proprietary processes have been developed by Ruland to maintain superior fit, finish, and holding power. MCL-75-F is stamped with the Ruland name and bore size for ease of identification. Forged screws test beyond DIN 912 12.9 standards to ensure maximum holding power. MCL-75-F is manufactured from solid bar stock sourced from select North American mills and machined to a fine burr free finish. Ruland uses 1215 lead-free steel with a proprietary black oxide finish that produces a fine glossy finish while increasing holding power and resisting corrosion. MCL-75-F is RoHS3 and REACH compliant and manufactured in our Marlborough, MA factory under strict controls using proprietary processes. Product Specifications Bore (B) Bore Tolerance Width Tolerance Recommended Shaft Tolerance Forged Clamp Screw Screw Material Alloy Steel Screw Finish Black Oxide Seating Torque Material Specification Finish Specification Hot Process Black Oxide, Impregnated with Naphthenic Oil, Centrifugally Dried Ruland Manufacturing Tariff Code Performance ratings are for guidance only. The user must determine suitability for a particular application. WARNING This product can expose you to the chemical Ethylene Thiourea, known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. Use the MCL-75-F one-piece shaft collar as it is received. Wipe the bore clean. Apply a thin coat of light oil to the shaft. Place the collar onto the desired shaft location and tighten it using a 6.0 mm hex wrench until a slight resistance is felt. 5. Wring collar into its final position and tighten the screw to the full recommended seating torque of 39 Nm using a 6.0 mm torque wrench. Ruland Manufacturing Co., Inc. 6 Hayes Memorial Drive • Marlborough, MA 01752 • Main 508-485-1000 • Fax 508-485-9000 • Email sales@ruland.com • www.ruland.com