Modular, rack mounting design > expandable to over 4000 inputs1ms time stamping of events across the whole system Up to 15,000 events stored perrack in distributed non-volatile memoryFlexible auto-shelving facility to avoid nuisance alarms Fully programmable via theprogramming port on the Interface Cardusing Windows- based configuration softwareFully integrated alarm annunciator functionality Wide range of optional displays >

Nuisance Alarms Interface Card Each alarm can be set to automatically inhibit (shelve) if the alarm frequency exceeds configured parameters and are therefore considered invalid. Alarms are automatically re-instated once they return to normal patterns. Each system is supplied with an Interface Card. Customer connections for remote printing and programming are provided on the front of this card.Configurable system relay outputs andthe RS485 serial output are available on the rear of the associated chassis. Once configured, settings are stored on EEPROM on the individual cards.In addition, the Interface...

Displays The System 9000TS is designed to work with almost any type of remote display ie. conventional backlit lamp or LED displays individual panel lamps or mimic diagrams RTK Instruments offer a range of display products to complement the 9000TS, these aredetailed in the Display Facias datasheet. Relay Outputs The standardsystem has outputs for all the commonly used functions, such as horn, watchdog, group and system fault relays. The watchdog relay is always provided, this will trip if any general fault occurs with the electronics. In addition to this thereare eight further configurable relays...

Complete Systems RTK can provide the System 9000TS mounted in a wall mounted or floor standing cabinet and provide all the necessary wiring to the displays, PSUs and terminals ready for final installation on site. These panels are quoted against each specific customer requirement; please contact the Sales Office for further details. Timers Delay timers can be incorporated into the System 9000TS on both the inputs and the outputs. This facility can avoid the possibility of nuisance alarms by setting an input time delay from 1ms to 65,000ms. Using this setting the alarm contact must be in alarm...

Hazardous Area Displays When supplied through suitable certified interface devices, the System 9000TS can be used to drive a display facia in the hazardous area. The DF30IS is a backlit display certified as Ex II 1G, EEx ia IIC T4. The display gives a bright LED illuminated backlit display that matches the safe area versions.The L20 Intrinsically Safe Multiplexercan also be used to drive a hazardous area display using only two cables into the hazardous area. > To complement the System 9000TS Alarm Annunciator, RTK Instruments offers a wide range of displays from simple lamp arrays to full mosaic...

Volt-free contacts which can havethe operating mode configured using the Setup Card, to operate toalarm for contact open or to alarmfor contact close. Alarm Contacts Lamp Drive (when Output Cards fitted) All inputs are opto-isolated (isolation voltage 2.5kV). By using different wiring configurations, the same system can be used for both: Each output can drive up to 160mA at 24VDC, making it suitable for multi bulb displays or multiple repeat displays. Standard Relays Eight standard relays fitted on the Interface Card, these are configurableassystem alarms such as watchdog,printer fault etc or...