S10 Intrinsically Safe Multiplexer Cost effective means of transferring digital signals Compact Fast response time Simple to understand and simple to use Power and signal transmitted on single cable pair Encapsulated electronics The S10 was introduced as the world’s first intrinsically safe Multiplexer and continues to provide a cost-effective solution to a common industrial need. The Multiplexer is sold as a matching pair consisting of a certified 10 channel transmitter and a safe area 10 channel receiver which work together to transfer digital signals from a hazardous area to the safe area over a single pair of cables. The transmitter accepts digital signals from switch or relay contacts in the hazardous area and transmits their status to the safe area receiver. Relay outputs on the receiver unit mirror the change in state of the digital inputs. A single cable pair is used both to transmit the signals from the hazardous area and also provide power to the transmitter

Technical Specification Operating Range Up to 2km Certification The hazardous area transmitter is ATEX certified to EN 50014:1997 and EN50020:2002 Outputs One changeover volt-free relay contact per channel energised when the field contact is open. Contacts rated at 1A @ 30VDC or 110VAC Group II, Category 1G, EEx ia IIC T5 (Ta -20ºC to 55ºC) Location Zones 1 or 2. Gas Groups IIC, IIB or IIA, Temp Class up to T5 Response time 6.4ms maximum LED outputs 12V via 1kohm resistor, 10mA per LED Recommended Interface Zener Barriers: MTL7715+, MTL7715P+ Safety Parameters See Certificate Receiver: Nominal...