TEMPERATURE Product Data Sheet Smart PT-100 Temp Transmitter INTRODUCTION: GEN206/P The GEN206/P is a cost effective “smart” in-head transmitter that accepts PT100 temperature sensors and converts sensor output over a configured range to a standard industrial (4 to 20) mA transmission signal. PC configuration allows the user to select Range, units and Burnout direction, without requiring calibration equipment. Configuration is performed quickly using our new USB port driven configurator by simply connecting two clips to the GEN206/P loop terminals and following the software instructions. Calibration set up may be saved as a file on the PC for later use. Sensor Type Senor Range Sensor Connection Minimum Span (*1) Linearisation Pt100 100 R @ 00C 2 or 3 wire -200 to +850oC [18-390 ohm] Screw terminal 25oC BS EN60751 (IEC 751) standard / JISC 1604 Measurement Accuracy (*2) 0.1oC ±0.05% of reading Thermal Drift 0.0025% / oC Excitation Current <200 µA Max Lead Resistance 20 ohms/leg Lead Resistance Effect 0.002oC/ohm Output Output Type Output Range Output Connection Max Output The GEN206/P in-head transmitter incorporates the latest digital technology to ensure accurate drift free performance. Equipment Computer Loop Voltage Effect Thermal Drift Max Output Load Running WindowsTM XP or later with USB port Comprising: USB configurator, leads, software downloadable 2 wire 4-20 mA current loop 4-20mA Screw terminal 21.5 mA (in high burnout condition) <3.9 mA (in low burnout condition) (mA output / 2000) or 5 µA (whichever is the greater) 0.2 µA/V 1µA/oC (Vsupply -10) K ohms 21 eg (700 ohms @ 24V) Method Load PC with USB_Link software. Connect USB Configurator to PC USB port using cable. Connect tool clips to GEN206 loop terminals red (+) black (-). Run software, set configuration required and save to device.

Mechanical details General Specification Update Time Response Time Start up Time Warm-up Time Power Supply 500 ms 1 second 4 seconds 1 minute to full accuracy 10-30 Volts dc Environmental Ambient Operating Range Ambient Storage Temp Ambient Humidity Range Physical Dimensions Weight 43 mm diameter; 21 mm height 31 g (encapsulated) Base View Electrical equipment for measurement control and laboratory use. Immunity test requirements for equipment intended for use in industrial locations. Test configurations, operational conditions and performance criteria for transducers with integrated or remote...