Axially Assembled, External Tamper-Proof The SHM also functions like an SH retaining ring, but in "smaller" applications. It is also a tamper proof ring which does not have any lugs and can not be easily removed once installed. Free Diameter & Ring Measurements Shaft Diameter & Clearance Diameter & with Section B-B Groove Dimensions Gaging Diameter *F.I.M. (FJLL INDICATOR MOVEMENTI-MAXIMUM ALLOWABLE DEVIATION OF CONCENTRICITY BETWEEN GROOVE AND SHAFT. i BASED ON HOUSINGS/SHAFTS MADE OF COLD ROLLED STEEL. FOR AN EXPLANATION OF FORMULAS USED TO DERIVE THRUST LOAD AND OTHER PERFORMANCE DATA, CONTACT THE ROTOR CLIP ENGINEERING DEPT. ***FOR PLATED RINGS, ADD .002" TO THE LISTED MAXIMUM THICKNESS. MAXIMUM RING THICKNESS WILL BE A MINIMUM OF .0002" LESS THAN THE LISTED GROOVE WIDTH (W) MINIMUM. INSTALLATION OF ROTOR CLIP SHM RINGS Rotor Clip SHM retaining rings can be installed by means of a tapered mandrel and a bushing. The mandrel can be eliminated in applications where the shaft can be easily tapered, as illustrated below. To install, place ring on mandrel and position bushing as shown. Ring can be pushed or tapped into groove. For the most up-to-date specifications, online ordering, quotations & sample orders, visit www.rotorclip.com

Maximum Corner Radius & Chamfer Exploded Groove Profile & Edge Margin (Y) Maximum bottom radii (R). Sharp corners- no radii for ring sizes -10 thru -37. LARGER SIZES MAT BE AVAILABLE UPON REQUEST. HARDNESS RANGES: BERYLLIUM COPPER RINGS "HARDNESS CAW WOT BE CHECKED WITH ANY DEGREE OF ACCURACY DIRECTLY ON THESE RINGS. 'HARDNESS CAN NOT BE CHECKED WITH ANY DEGREE OF ACCURACY DIRECTLY ON THESE RINGS. PRODUCTION OF MANDREL AND BUSHING "HARDNESS CAN NOT BE CHECKED WITH ANY DEGREE OF ACCURACY DIRECTLY ON THESE RINGS. Specifications for the production of a mandrel and bushing for installing SHM rings...