Quote Form For TRUWAVE Wave Springs

Product catalog summary

Overview: This document is a quote form for TRUWAVE Wave Springs, provided by Rotor Clip. It is intended for applications where standard catalogue items are not suitable, allowing for custom-designed wave springs without high tooling costs.

Contact Information: Users are required to fill out their contact details including name, company, address, phone, fax, and email.

Radial Guide / Pilot: The form requires information on the radial guide or pilot needed for the wave spring to prevent skipping of turns. Options include piloting in bore diameter, over shaft diameter, clinging in bore diameter, or on shaft diameter.

Load Specifications: Users must define the load requirements at specific work heights, specifying whether the application is static or dynamic. Load values can be provided in either metric or imperial units.

Cycle Life: The required cycle life of the wave spring must be specified, with options ranging from less than 10⁴ cycles to more than 10⁶ cycles.

Operating Conditions: Users need to specify the maximum operating temperature and any materials the spring will contact.

Type: The form lists various types of wave springs, including one turn with gap, one turn with overlapping ends, multiple turns with plain or parallel ends, and multiple nested turns.

Material: Standard materials include Carbon Spring Steel and 17-7PH Stainless Steel, with special grades such as AISI 302, Elgiloy, AISI 316, Hastelloy C276, and others available.

Finish: Users must specify the finish requirement, with options like oiled, vibratory finishing, electropolish, degreased & ultrasonic-cleaned, black oxide, passivation, and deburring.

Volume and Delivery Time: Information on prototype and series volume, as well as delivery time, is required.

Description of Application / Sketch: A section is provided for users to describe the application or include a sketch.

Catalog excerpts

Quote Form For TRUWAVE Wave Springs As soon as a standard catalogue item cannot be considered for your application, Rotor Clip can offer custom designed wave springs without expensive tooling costs and with regards to your specification criteria. Please fill out this form and send it to the Rotor Clip engineering department (Fax: +1-732-805-6474, E-Mail: [email protected]) which will check a feasible wave spring design with regards to your specifications. Cycle Life Please specify the required cycle life: □ Static Application □ 105 Cycles □ > 106 Cycles □ < 104 Cycles □ 106 Cycles Please define under which conditions the wave spring is expected to operate: Max. Temperature: °C / °F The spring will be in contact

Open the catalog to page 1

Quote Form For TRUWAVE Wave SpringsType One turn with gap One turn with overlapping ends □ Material (Standard) □ Carbon Spring Steel (SAE 1070 - 1090) □ 17-7PH Condition CH900 Stainless □ AISI 302 Stainless (DIN Material No.: 1.4319) □ AISI 316 Stainless (DIN Material No.: 1.4401) □ A286 (DIN Material No.: 1.4980) □ Inconel X-750 (DIN Material No.: 2.4669) □ Elgiloy (DIN Material No.: 2.4711) □ Hastelloy C276 (DIN Material No.: 2.4819) □ Beryllium-Copper (DIN Material No.: 2.1247) □ Phosphor-Bronze (DIN Material No.: 2.1030) □ Oiled (Standard with Carbon Spring Steel) □ Vibratory Finishing...

Open the catalog to page 2