Series 700 Direct-Driven Specifications and Dimensions Series 700 Direct-Driven STANDARD FEATURES: AVAILABLE OPTIONS: • Higher tip speeds up to 18,000 feet per minute can be obtained by using special inverter duty motors. • 230/460 volt, 60 Hz., three phase, explosion proof motors (see options for starters and controls). • Extra heavy duty bearings and forced oil cooling for continuous processing of high viscosity materials. • Tip speeds of 11,300 feet per minute. • Special motors including, inverter duty, wash-down and stainless steel as well as special voltages and frequencies are available. • Heavy-duty shafts and bearings as well as extremely tight machining tolerances. • X-Series or Quad Slot rotor/stator sets. • Special double mechanical or gas-purged seals available. • Equipped with a cartridge type double mechanical seal and barrier system. • Sanitary designs with special seals, polished components and sanitary connections available. • Type 316 stainless steel wetted parts. • Jacketed mixing chamber for heating or cooling. • NPT threaded connections on units through 10 HP. Larger units use standard ANSI flanges. • Portable carts mounted on casters are available in either carbon or stainless steel. • All non-stainless steel external surfaces coated with a white two part epoxy paint. • Skid mounted recirculating systems including vessel, piping and valves. • Controls such as inverters, motor starters, or explosion proof operators stations are available (voltage, frequency and type of enclosure must be specified). D E O.A. Height Direct O.A. Length mm mm " " * * * * * These models are available in belt-driven versions only, please refer to other side of this sheet. **Dimensions and weights are based on lowest horsepower motor for each model. Consult factory for dimensions and weights of other horsepowers. CHARLES ROSS & SON COMPANY P.O. Box 12308, 710 Old Willets Path, Hauppauge, NY 11788 • Fax: 1-631-234-0691 • Tel: 1-631-234-0500 Website: www.mixers.com • Email: [email protected]

Series 700 Belt-Driven Specifications and Dimensions STANDARD FEATURES: • 10 through 300 HP. • 230/460 volt, 60 Hz., three phase, explosion proof motors (see below for starters and controls). • Tip speeds of 11,300 feet per minute. • Heavy-duty shafts and bearings as well as extremely tight machining tolerances. • X-Series or Quad Slot rotor/stator sets. • Equipped with a cartridge type double mechanical seal and barrier system. • Type 316 stainless steel wetted parts. • NPT threaded connections on units through 10 HP. Larger units use standard ANSI flanges. • All non-stainless steel external...