BANTAM REGULATORS Port sizes 1/8 and 1/4 or fittings for tubing up to 10 mm. Modular units have durable plastic, corrosion-resistant bodies. A non-relieving version can be used with water, oil, and many other liquids. MINIATURE REGULATORS Port sizes 1/8, 1/4. Aluminum-bodied units for inline mounting. Same performance characteristics as the BANTAM models. Brass or stainless steel bodies, and water pressure models are also available.MINIATURE regulators are available to provide outstanding pressure control at relatively low cost. A large diaphragm area gives high sensitivity, and a small valve seat gives greater precision and little variation in outlet pressure from fluctuations in supply pressure. With an inlet pressure of 100 psig (7 bar), repeatability is within 1/4 psig. Regulated pressure range is 060 psig (0֖4.1 bar). Optional springs allow other pressure ranges. MID-SIZE REGULATORS Port sizes 1/4, 3/8, 1/2. Modular units in a balanced-valve, piston design with very quick response for fast-cycling valves and cylinders. Two sub-series: models with durable plastic dome, and models with high-strength metal dome for more severe environments. Regulation performance is essentially the same. MODULAR or INLINE MOUNTING Regulators are connected to filters or lubricators by special modular connectors which seal the faces between units. They may also be inline mounted with pipe nipples. MINIATURE and HIGH-CAPACITY regulators are inline mounted only. > ROSS regulators are made in a wide range of sizes to suit nearly all industrial requirements for pneumatic pressure regulation. Good pressure regulation is essential to the efficient use of pneumatic equipment. A compressor may supply air at 150 psig, but most of the equipment will operate best at lower pressures. A cylinder, for example, may develop sufficient force for its purpose with 50-psig air. Remember that compressed air is costly, so using higher air pressure than necessary is wasteful, and may also shorten the life of the cylinder. A general purpose pressure regulator is the answer for greater economy and efficiency. Regulators are of two basic designs. Piston design provides highest air flow; diaphragm design provides high sensitivity and quick response. All regulators are self-relieving, but a non-relieving option is available. A pressure gauge is standard, and gauge ports are at the front and the rear of each unit.In addition there are precision regulators in all port sizes for applications demanding extra precision in the regulation of air pressure, plus regulators for remote piloting. > 50 2008, ROSS CONTROLS ɮ . All Rights Reserved. size="-2">

Port sizes 1/8 and 1/4. A pressure gauge is standard equipment. FULL-SIZE Regulators are of diaphragm design for high sensitivity. They provide air flow up to 160 scfm (75 l/s) in applications where low pressure drop and/or remote adjusting are desired. HIGH-CAPACITY Regulator s are of diaphragm design, and provide air flow up to 600 scfm (284 l/s). REVERSE FLOW REGULATOR PRECISION REGULATORS HIGH-CAPACITY Regulators ROSS reverse-flow regulators provide regulated pressure control from in-to-out, and quick exhausting from out-to-in. When the inlet side of the regulator is exhausted, the regulator...