ALVEOTUBE® The best compromise on the market between bending resistance and low inertia « IDLER ROLL » ASSEMBLIES Assembly Ball bearing is fixed in a machining in the inner diameter of the ALVEOTUBE® profile A rigid plate (in steel or aluminium) is fixed in the outer diameter of the ALVEOTUBE® profile A rigid plate is fixed in the inner diameter of the ALVEOTUBE® profile Possible ball bearings • Radial with reinforced sealing • Radial and low friction • Self-aligning with reinforced When the profile is thick enough (from 3RC80) a safety ring groove can be done in order to block the ball bearing in the profile • Self-aligning without sealing • Radial with reinforced sealing • Radial and low friction • Self-aligning with reinforced sealing • Self-aligning without sealing Possibility of passing through shaft or end shafts Rigid plate designed for 2 or 1 sole ball bearing. • Radial with reinforced sealing • Radial and low friction Possibility of passing through shaft or end shafts. Reduction of inertia compared with RE assembly. A rigid plate is fixed in the inner diameter of the ALVEOTUBE® profile • Radial with reinforced sealing • Radial and low friction Alternative to long rigid plate for smaller shafts. Reduction of inerti