aluCLIC
6Pages

Catalog excerpts

aluCLIC Aluminium enclosures on snap-on device

Technical data aluCLIC Enclosure front fully usable Click on instead of screw on Lid screwed on rear side More space for the electronics Snap-on device Integrated recess for membrane keypads Enclosure: Die-cast aluminium EN AN-44300 DIN EN 1706 (GD AL SI 12 / DIN 1725). 1° mould slope for casting ejection, internal measures diminishing circulatory towards enclosure bottom by 1°. Optionally available: Integrated recess: In the lid for membrane keypad or front plates Components: Fastening thread M5 in the bottom and lid Ingress Protection: IP66 / EN 60529 Gasket: TPE moulded gasket,...

Open the catalog to page 2

□ Standard # Available O Not available Mounting dimensions

Open the catalog to page 3

ROLEC Attachment and mounting dimensions aluCLIC 130 119* 94* Snap-on device Schnellwechselträger * Pleasebeachten: Gehäusewand mit Entformungsschräge, Maßangaben in Höhe des Gehäusebodens! * Bitte note: Mould slope for casting ejection, dimensions in the amount of the bottom! Snap-on device Schnellwechselträger 85 108 133 * Pleasebeachten: Gehäusewand mit Entformungsschräge,amount of the bottom! * Bitte note: Mould slope for casting ejection, dimensions in the Maßangaben in Höhe des Gehäusebodens!

Open the catalog to page 4

Schnellwechselträger Snap-on device ** Please note: Mould slope for casting ejection, dimensionsMaßangaben in Höhe des Gehäusebodens! Bitte beachten: Gehäusewand mit Entformungsschräge, in the amount of the bottom!

Open the catalog to page 5