DOUBLE SHEET DETECTION SENSOR BRACKET SHX42 FOR DOUBLE SHEET DETECTION ● Decompressed condition: very stiff, for lateral acceleration up to 2g, precise putting on the sheet without canting ● Compressed condition: very elastic and movable into all directions ● Minimal wear due to absence of lateral forces, short reaction ● time, low height ● Good access to the sensor from above, no counter-nuts r

SENSOR BRACKET SHX42 Mounting of the sensor bracket: The mounting plate has a total of 10 M8 tap holes at distances of 50 and 100 mm. At least 2 of them must be used for mounting. Adapters with Ø 19 and 25 mm stud for swivel arm are available. Other adapters may be ordered by request. Item 1 - 4 describes the mounting of the sensor into the sensor bracket and item 5 - 8 describes the mounting of the sensor bracket. Risk of injury! Please use gloves while screwing in the sensor 1. Lightly grease sealing HINT: Compress the sensor bracket for better handling. Eventual pull off the vacuum hose. Vacuum...

Spring loaded sensor bracket Spring loaded sensor bracket with flat suction cup Spring loaded sensor bracket with bellow suction cup Spring loaded sensor brackets with rubber lip respectively double lip. Read the NOTE at the bottom for SHX42-DL! Sensor mounting | 0 43 mm | Thread M42 x 1.5 | Thread M42 x 1.5 | Thread M42 x 1.5 | Thread M42 x 1.5 Total height* 98 mm plus 141mm 128 mm 120 mm 120 mm sensor excess length Spring travel_| approx. 26 mm | approx. 26 mm | approx. 34 mm approx. 70 mm approx. 70 mm Weight approx. 0.75 kg (1.65 lbs) approx. 1.12 kg (2.46 lbs) approx. 1.2 kg (2.64 lbs) approx....