DOUBLE SHEET DETECTION SENSOR BRACKETS FOR DOUBLE SHEET DETECTION ● The best suited mounting solution for each requirement ● For best sensor contact, even at inclined or bended sheets ● For reliable, durable and best measurement results, for Double Sheet Detection and best protection of your subsequent production stages ● Durable design and high quality components guarantee a minimum of maintenance and a maximum of reliab

SENSOR BRACKETS Order information Spring loaded sensor bracket with rubber lip FOR DOUBLE SHEET DETECTION (SINGLE-SIDE SYSTEMS) Spring loaded sensor bracket with double lip Spring loaded sensor bracket Spring loaded sensor bracket with flat suction cup Spring loaded sensor bracket Spring loaded sensor bracket with flat suction cup Mounting Total height (unloaded) Spring loaded sensor bracket with bellow suction cup (red) SHS42G-FB_GE (yellow) Optimal flexibility Suited for 98 mm, plus sensor excess length 98 mm, plus sensor excess length Spring travel + suction cup compression approx. 34 mm (plus...

The suction delay time is strongly dependent on vaccuum strength, tube resistance, contact angle and contact pressure to the sheet. Never use the sensor brackets as a lifting device! (Except sheet is smaller than the area of 3 suction cups.) Revision 2.3, January 2025 - Subject to technical modification and error (Legend: „x x" = absolutely not suited / „x" = not suited / „o" = applicable / „+" = well suited / „++" = best suited) ROLAND ELECTRONIC GmbHOtto-Mau rer-Strafie 17 75210 Keltem / Germany phone: +49 7236 9392-0 fax: +49 7236 9392-33 [email protected] www.roland-electronic.com...