Industrial acoustic sensor
4Pages

INTELLIGENT MEASURING EQUIPMENT www.roga-instruments.com ROGA MI-17 These 1/4"-measuring microphones are pressure transducers. The model MI-17 have integrated electronics, and can be delivered with sensitivities from 10 to 100 mV/Pa at tolerances of within ±1. 5 %. Special custom versions are also possible. Power supplies for the microphones can be either a constant current source of 2 – 6 mA (standard version) or a constant voltage source 4 – 30 Volts. Normally the microphones are fitted with BNC-connectors (fem.) allowing standard BNC-BNC cables to be used. Other connectors such as TNC, SMB, Lemo or µdot are also available on request. These microphones are quite suitable for array applications. ROGA-Instruments, Steinkopfweg 7, D-55425 Waldalgesheim Phone: +49 (0) 6721-98 44 54, Fax: +49 (0) 6721-98 44 74 Compact Microphone TECHNICAL DATA (Type 1): Analog Inpu Frequency response (typical) 30 Hz – 4 kHz: ± 0.5 dB 4 kHz – 20 kHz: ± 1.5 dB Temperature range -10 – +50 °C Sensitivity Ϸ 50 mV/ Pa Noise (Lin: 20 Hz – 20 kHz) Ϸ 35 dB (SPL) („A“-wighted) Ϸ 26 dB (SPL) Max. peak SPL Ϸ 130 dB (ref. 20µPa) Constant supply current 2 – 6 mA Output impedance 50 ⍀ Dimensions – total length 93 mm Tube – diameter 8 mm Connector BNC (fem.) Weight 23 grams

INTELLIGENT MEASURING EQUIPMENT www.roga-instruments.com ROGA RG-50 These 1/4"-measuring microphones are pressure transducers. The model RG-50 have integrated electronics, and can be delivered with sensitivities from 10 to 100 mV/Pa at tolerances of within ± 5 %. Special custom versions are also possible. Power supplies for the microphones can be either a constant current source of 2 – 6 mA (standard version) or a constant voltage source 4 – 30 Volts. Normally the microphones are fitted with BNC-connectors (fem.) allowing standard BNC-BNC cables to be used. Other connectors such as TNC,...

INTELLIGENT MEASURING EQUIPMENT www.roga-instruments.com ROGA MP40/PA-01 IEPE 1/2” Measurement Microphone ROGA MP40/PA-01 • Constant current powered measuring microphone preamplifier PA-01 with electret condenser microphone capsule type MP40. The current powered 1/2” Measuring Microphone offers facilities for the use of a high-quality noise measurements. • Typical applications like array arrangements and covered area measuring procedures, e.g. automotive acoustics, can be taken into account. • This acoustic sensor can be connected to any IEPE input via BNC cable. The PA-01IV preamplifier...

INTELLIGENT MEASURING EQUIPMENT www.roga-instruments.com ROGA MU-10 1/4” Measurement Microphone with USB PC interface ROGA MU-10 USB measurement microphone, is a new generation of digital measurement microphones. TECHNICAL DATA: • The MU-10 is an easy to use sensor, which is detected by the PC as USB Audio device. • Flexible sensitivity adjustmet. • RogaREC & VA FFT spectrum analyzer software is included. Connector Capsule ADC Dynamic Range Sensitivity Bandwidth Housing Diameter Length Power Supply 4 Pin Lemo with 3 Meter USB cable 1/4” 16 bit Delta Sigma 87 dB 8-200 mV/Pa adjustable 10...