Catalog excerpts
INTELLIGENT MEASURING EQUIPMENT www.roga-instruments.com AS-10 Professional Microphone for Acoustical Quality Assurance AS-10 The AS-10 is a compact professional microphone which is used to hear and to evaluate airborne noise. It has a length of 30cm and is equipped with a goose neck with a length of 30 cm. To the output receptacle at the back a headphone can be connected. The power supply is realized with a 9V block battery, which is located on the bakkside of the device. The battery can be changed by unscrewing the rear tube. After unscrewing the battery can be accessed and changed. After the device is switched on, the green operation LED is lit. The unit offers two amplification ranges with 30dB and 60dB. The volume fine adjustment for the headphone is performed with the latching potentiometer (11 positions) on the user panel. ROGA Instruments does not take any liability for the correctness and/or completeness of the descriptions contained herein. We reserve the right to change any properties and/or descriptions and documents at any time without any prior announcement. The brightness of the LED decreases if the battery voltage drops below 8V. At 7V the LED is weak. At this time the battery should be changed immediately. Up to this supply value all specifications are kept operative. The only exception is the maximum output voltage. PROPERTIES: • Flexible goose neck microphone • Headphone amplifier • Operated with an integrated battery • Single-handed operation APPLICATIONS: • Measurement of airborne noise • Engine diagnostics • Locating noise sources • Detection of acoustical disturbance sources
Open the catalog to page 1Acoustical operating principle pressure-gradient transducer Directional pattern cardioide Front to back ratio 20 dB Frequency response see diagram Pressure sensitivity @ 1000Hz approx. 50mV/Pa Total harmonic distortion @ 28Pa (123dB) SPL < 3% Range of supply voltage 0,8...15V Operating Conditions Temperature storage Temperature operation Relative humidity Weight incl. battery FREQUENCY RESPONSES ROGA RECOMMENDATION Roga Instruments offers necessary Lemosa HEADPHONE AMPLIFIER: SPECIFICATIONS Total harmonic distortion: Output impedance: Power supply: Current consumption: approx. 7mA with...
Open the catalog to page 2All ROGA-Instruments catalogs and technical brochures
-
RogaDAQ 4
1 Pages
-
152A Series
1 Pages
-
RogaDAQ2
15 Pages
-
RogaDAQ 16
2 Pages
-
RogaREC
1 Pages
-
SLM & SPM
2 Pages
-
FlexPro
16 Pages
-
DASYLab
4 Pages
-
MI 17
1 Pages
-
RG 50
1 Pages
-
RG-20-PC
1 Pages
-
MU-10 USB
1 Pages
-
FastTracer
12 Pages
-
AS 10
2 Pages
-
Impulse hammers
1 Pages
-
Industrial acoustic sensor
4 Pages
-
MP41 1/2" IEPE
1 Pages
-
RogaDAQ1
1 Pages
-
Plug.n.DAQ USB Front-End
1 Pages
-
Diamond 401
4 Pages
Archived catalogs
-
MI-17 IEPE Microphone
1 Pages