WS 1.3020 Workholding Systems EL clamping against the fixed jaw, mechanically operated with hydraulic force transmission jaw widths 100, 125 and 160 mm Advantages ● Steel base resistant to deformation ● Hydraulic force transmission ● Hardened and ground guideways ● Extensive range of jaws ● Easy clamping range adjustment by quick socket pin adjustment ● Angle drive or clamping force preselection can be retrofitted (accessories) ● Minimum set-up times ● Tapped hole in the fixed jaw for workpiece stop ● Clamping edge for clamping claws ● Quick cleaning by simple removal of the slide Application Workholding systems EL are advantageously used in vertical machining for die, mould and fixture construction. Accessories See data sheet WS 1.300Z • Clamping and quick-change jaws • lamping force preselection C The clamping force preselection enables the force to be applied in 6 stages up to the maximum. Description The workholding systems EL can be flexibly and quickly adapted to the most varied clamping ranges because of their socket pin adjustment. Thanks to the hydraulic force transmission, the desired clamping force is achieved with a minimum effort on the crank handle. The workholding system can be easily and quickly cleaned by pulling out the socket pin and removing the clamping slide from the base. Thus cost intensive downtimes will be reduced. Technical data Clamping principle: clamping against the fixed jaw mechanical Operation: by crank handle with hydraulic force transmission EL 100 Jaw width: 100 mm Clamping force: 25 kN Max. jaw opening: 205 mm EL 125 Jaw width: 125 mm Clamping force: 40 kN Max. jaw opening: 225 mm EL 160 Jaw width: 160 mm Clamping force: 50 kN Max. jaw opening: 309 mm Consultation Our experts will be pleased to advise you also on site, and work with you to find the optimum clamping solution. Extensive information such as drawings and CAD models are available on request. • Angle drive An angle drive that can also be retrofitted facilitates the operation, e.g. in the case of longitudinal clamping on the machine table. • Workpiece stops • Accessories for fixation Delivery • Standard jaws smooth/serrated • Crank handle Application example ROEMHELD · 927 Horan Drive, Fenton, MO 63026 · Phone: (314) 386-8022 · Fax: (314) 386-8034 · [email protected] Ac

Technical data Dimensions EL 100 Standard jaws smooth/serrated (included in the delivery) View from above Standard jaws smooth/serrated (included in the delivery) Standard jaws smooth/serrated (included in the delivery)  * Tolerance ± 0.01 mm ** Tolerance ± 0.02 mm All dimensions in [mm] Clamping principle Clamping force  Weight with clamping jaws Part no. with clamping jaws 1) with the clamping jaws shown. Further clamping jaws and accessories on data sheet WS 1.300Z.