B 1.309 Threaded-Body Universal Cylinders single and double acting, max. operating pressure 500 bar Installation possibilities Description The threaded-body universal cylinders are d elivered with the same piston diameters and strokes as the well-proven block cylinders. H ydraulic connection is exclusively effected at the cylinder bottom by hydraulic tubes or hoses. Sealing of the case-hardened piston rod is made by a tandem sealing with minimum leakage and a wiper. Application The threaded-body universal cylinders can be used as clamping cylinders for workpiece clamping as well as for general motion tasks. For temperatures exceeding 100 °C a ersion v with FKM seals is available. Fixing is made in cross holes with 2 lock nuts or in threaded holes with 1 lock nut. The lock nuts allow exact positioning of the cylinder in axial direction. Advantages ● 6 piston diameters from 16 up to 63 mm ● 3 different strokes per size ● Sealing with very little leakage ● Alternatively single acting with spring return or double acting ● Connecting thread at the cylinder bottom ● Axial regulation due to external thread ● Lock nuts as per DIN 1804 can be used ● Space-saving fixing in fixture walls ● Swarf-protected tubing is possible ● Piston rod with internal thread for fixing of different contact bolts Venting of the spring area for single-acting versions If there is a possibility that aggressive cutting lubricants and coolants penetrate through the sintered metal air filter into the cylinder‘s interior, a vent hose has to be connected and be placed in a protected position, see data sheet G 0.110. Vent hose For this purpose the sintered metal air filter has to be exchanged by an insertion nipple fitting, or a corresponding male connector, see data sheet F 9.300. Important notes Operating conditions, tolerances and other data see data sheet A 0.100. Application examples

Technical data Only for type: 13X1 XXX SW 13X3 XXX 13X4 XXX Stroke ± 1 Total length l ± 1 Weight Part no. Stroke ± 1 Total length l ± 1 Weight Part no. Accessories Part no. lock nut DIN 1804 * only for 1311 025, -225 and 1341 165, -195, -365, -395 Part-nos. for versions with FKM seals for temperatures exceeding 100 °C up to 150 °C 13XX XX6 Contact bolts see data sheet G 3.800. Double acting Stroke ± 1 Total length l ± 1 Weight Part no. Stroke ± 1 Total length l ± 1 Weight Part no. Single acting with spring return Stroke ± 1 Total length l ± 1 Weight Part no. Bleeding by plug with sintered metal...