Program summary Block Cylinders
6Pages

{{requestButtons}}

Catalog excerpts

Program summary Block Cylinders - 1

Program Summary BLOCK CYLINDERS Single and double acting Steel, aluminium and bronze bodies Piston diameter from 16 to 200 mm Position monitoring Stroke end control Stroke end cushioning Anti-torsion device

Open the catalog to page 1
Program summary Block Cylinders - 2

HILMA - STARK Data sheet Functioning Force to push at max. pressure Piston diameter Piston stroke Max. piston speed Admissible piston side load Seals and max. operating temperature 1 Housing material Stainless steel version Hydraulic connection Stroke limitation by distance bushing Housing with keyway pipe thread pipe thread pipe thread pipe thread flange with O-ring sealing flange with O-ring sealing flange with O-ring sealing flange with O-ring sealing double acting 40.2 ...251.3 kN 32 . 80 mm 25 ... 100 mm 0.50 m/s as per diagram as per diagram up to +200 °C steel Housing with...

Open the catalog to page 2
Program summary Block Cylinders - 3

Pull-type cylinder single acting double acting double acting double acting double acting pipe thread pipe thread flange with O-ring sealing pipe thread flange with O-ring sealing pipe thread flange with O-ring sealing pipe thread flange with O-ring sealing proximity switch inductive pressure resistant 1... 4 mm before end position +80 °C ... +120 °C proximity switch inductive pressure resistant 1... 4 mm before end position +80 °C ... +120 °C position monitoring inductive moveable over the entire stroke +70 °C ... +120 °C magnetic sensor magnetoresistive moveable over the entire stroke +100...

Open the catalog to page 3
Program summary Block Cylinders - 4

Block cylinder with aluminium housing for magnetic sensors NBR: +100 °C FKM: +120 °C alu O pipe thread flange with O-ring sealing □ □ O magnetic sensor magnetoresistive moveable over the entire stroke +100°C pipe thread flange with O-ring sealing ■ ■ O proximity switch inductive pressure resistant 1... 4 mm before end position +80 °C ... +120 °C

Open the catalog to page 4
Program summary Block Cylinders - 5

Important technical information Admissible piston side load For all hydraulically operated linear movements. If the piston rod is loaded with a side load, higher wear must be expected. For strokes up to 50 mm, the side load should not be higher than 3 % of the max. piston push force. Single acting The block cylinder S and the hydraulic block The hydraulic force acts only in one axial di- cylinder are equipped with high-quality guide rection. The return stroke is effected by spring rings. The admissible side load can be taken force or by external forces. from the diagrams on the data sheets....

Open the catalog to page 5
Program summary Block Cylinders - 6

Important technical information Piston with anti-rotation device Position monitoring complete Accessory - Contact bolts Block cylinder with aluminium housing and pis- Is mounted to the cylinder bottom of block cyl- Different contact bolts and coupling pins as per ton rod with polygonal profile. inders with extended piston rod. data sheet G 3.800. The inductive proximity switches are movable and can monitor the complete piston stroke. Piston with stroke end cushioning Observe minimum distance between adjacent The damping effect can be adjusted for block switching points as per data sheet....

Open the catalog to page 6

All Römheld GmbH Friedrichshütte catalogs and technical brochures

  1. Rotor locks

    6 Pages