Press-in devices
6Pages

{{requestButtons}}

Catalog excerpts

Press-in devices - 1

B ROEMHELD 44 HILMA ■ STARK Press-in devices from the modular system Products for productivity

Open the catalog to page 1
Press-in devices - 2

HILMA - STARK Everything from a modular system The modular system consists of matched components that can be combined according to the requirements. The performance spectrum comprises: • Press forces up to 100 kN • Strokes up to 400 mm • C-frame and portal design • Various control variants The program is supplemented by workpiece feed systems as per data sheets P 9.1XX. They ensure an optimum workpiece flow and thereby support the ergonomics and work efficiency. Based on our long-standing experience in the manufacture of most different press-in devices, we developed the modular system...

Open the catalog to page 2
Press-in devices - 3

Force and stroke classes Hydraulic cylinders Maximum press forces: 40, 63 and 100 kN Strokes: 100, 200, 300 and 400 mm Recommended minimum press force: approx. 10 kN Electric cylinders Maximum press forces: 7 and 25 kN Strokes: 100, 200, 300 and 400 mm Hydraulic basis variants (data sheet P 1.102 and P 1.202) The press force is determined by the adjustable pressure. After short stop time, the control switches automatically to return stroke. Control variant 1 Effectiveness and safety due to rapid/creep speed. It is adjustable by entering, how far away from the workpiece switching to creep...

Open the catalog to page 3
Press-in devices - 4

Quick and flexible Alternatively quick-change tooling systems are available with contact piece in pendulum or fixed version. Both variants have the same length so that also in this case flexibility is given for the adaptation to different workpiece requirements. The contact piece has 4 counterbores M6 in the hole circle 0 84 mm. For the alignment a counterbore 0 20 mm with fit H7 is used. Comfortable control The output touch-panel (control variant 1) and also the monitoring touch-panel (control variant 2) are available. They allow the complete operation of the press-in device, an error...

Open the catalog to page 4
Press-in devices - 5

Assembly of pneumatic cylinders Pressing-in of bushings for cylinder guide rods • Versatile use for 186 different cylinder types • Precision of press-in depth of < ± 0.1mm • Considerable reduction of set-up times Workshop press for repair works Pressing in and out of components • Versatile usability • C-frame for optimum accessibility • Simple operation with two-hand release Assembly of hydraulic components. Pressing in of sophisticated, slim components • With moving carrier plates for workpiece supply • Automatic sequence with pneumatic door operation • Complete protection cabin with...

Open the catalog to page 5
Press-in devices - 6

Assembly of aluminium pistons Joining of divided aluminium pistons • Triple press-in device • Alternative actuation of the three press axes • Gap-free feed up of both components Assembly of planetary gears Pressing in of gear shafts in gear cases • Handling process combined with joining process • Flexible complete system for 12 different gear sizes • mobile C-frame with assembly lifting and rotating table Assembly and disassembly of rail brake cylinders Tense and release of pressure spring packs • Transmission of high forces • Restoring forces of the pressure springs are held under defined...

Open the catalog to page 6

All Römheld GmbH Friedrichshütte catalogs and technical brochures

  1. Rotor locks

    6 Pages