COMPLETE CATALOGUE "DISC BRAKES" - 7 Pages

Add to MyDirectIndustry favorites
COMPLETE CATALOGUE "DISC BRAKES"

Catalog excerpts

Q u al i t y. S a fe ty. Effic ie n c y. Only Quality is economical in the long run German specialist in brake + safety technology. B re m ssyste m S c h e i b en b re msen R S T, C aliper SCFH B ra k e S y s tem D i s c B rak e s R S T, C alip er SCFH Technische Daten / Zeichnung technical data / drawing 140717

 Open the catalog to page 1

Disc Brake RST Electro-hydraulic actuated Technical Data RÖMER Fördertechnik GmbH Nielandstraße 53 * D-58300 Wetter The drawing shows the brake in right hand design R. The left hand design L is mirrored to the drawing. Thrustors turned by 90° can be mounted. In this case please ask for changed dimensions. For thrustors acc. to DIN 15 430 are different manufacturers of products available. Notes for following table: 1) The different operation factors such as sliding speed, surface pressure, thermal load, condition of the sliding surfaces, brake drum material and environmental conditions can...

 Open the catalog to page 2

Disc Brake RST Electro-hydraulic actuated Technical Data Size RST 1 Thrustor to DIN 15 430 lifting gab ca. 1,25 mm at each brake shoe C Brake disc RÖMER Fördertechnik GmbH Nielandstraße 53 * D-58300 Wetter Brake lining lifting gab ca. 1,5 mm at each brake shoe C lifting gab ca. 1,5 mm at each brake shoe C Data in ( ) width of brake disc B1 = 40 mm Tel.: Fax: eMail: info@roemer-foerdertechnik.de Internet: www.roemer-foerdertechnik.de

 Open the catalog to page 3

Disc Brake Caliper SCFH Direct acting, hydraulic release. Seite 1 von 4 Nielandstraße 53 * D-58300 Wetter Operating Principle • Spring applied braking force Hydraulic release Fail Safe (if power fails the brake applies) Direct acting without linkages • Fixed, not floating Notable Features • High braking torque, direction of rotation independent Supplied ready assembled, with pre-tensioned braking springs Two identical halves, and can be mounted in any position Manual adjustment for brake wear. Air-gap adjustable in the range 1=3mm standard low wear sintered pads with µ = 0,4 Encapsulated...

 Open the catalog to page 4

Disc Brake Caliper SCFH Direct acting, hydraulic release. Seite 2 von 4 Nielandstraße 53 * D-58300 Wetter Monitoring switches to indicate brake open/closed Manual release, using a hand pump on the Hydraulic Power Pack Hydraulic Power Pack, which can also be configured to operated multiple calipers Special versions for very high or very low temperatures Hydraulic systems for ultra-low flammability hydraulic fluids Brake discs either with hub or flange mounting Technical Data Performance Data: Pad force F Spring Pack Brake Pad Friction Coeff. Surface area 1) [cm²] µ Hydraulic Release Pressure...

 Open the catalog to page 5

Disc Brake Caliper SCFH Direct acting, hydraulic release. Seite 3 von 4 Nielandstraße 53 * D-58300 Wetter Determining the Brake Torque: The effective brake torque of a complete brake caliper is calculated using the following formula The effective diameter D1 can be found using the formula on page 4. Alternatively, the effectice braking torque can be taken from the displayed diagram. Combinations from size 1 and 3 substitute the sizes 2 and 4. Example: 4 x SCFH – 3 => 960 kN (contact force) for s = 2 mm (airgap) Special Design and combinations on request! Dimensions dependent on the brake...

 Open the catalog to page 6

Disc Brake Caliper SCFH Direct acting, hydraulic release. Seite 4 von 4 Nielandstraße 53 * D-58300 Wetter Mounting surface Mounting surface Brake Disc Dimensions in mm Technical modifications reserved! eMail: Internet: info@roemer-foerdertechnik.de rft-germany.com Technical modifications reserved - 140717

 Open the catalog to page 7

All Römer Fördertechnik GmbH / RFT catalogs and technical brochures

  1. PUDZ III

    9 Pages

  2. HERKULES II

    4 Pages

  3. BAND BRAKES

    2 Pages

  4. IPS

    6 Pages