CHROMA™ Visible-Infrared Focal Plane Electronics CHROMA™ (Configurable Hyperspectral Readout for Multiple Applications) is an advanced focal plane array (FPA) developed for visible-infrared spectral imaging applications. The CHROMA Focal Plane Electronics (FPE) board provides interface, control, and I/O support for CHROMA and other ROIC-based sensors. Based on a Xilinx Virtex-6 FPGA, the board interfaces to the analog outputs and timing signals of the CHROMA ROIC, samples the output signals, and converts the data to a Camera Link compatible signal. FPE CHARACTERISTICS Supports up to 8 analog outputs from a CHROMA ROIC Independent 16-bit A/D converter for each analog channel 10 MHz pixel clock frequency (can be customized in FPGA logic) Support for full frame or sub-frame window sizes Full Camera Link interface with mini-sized connectors Two onboard A/D converters for generation of DSUB & REF bias diagnostics Host control Camera Link serial port (COM port drivers eases development of host control software) Four low noise ROIC power supplies Teledyne Imaging Sensors 5212 Verdugo Way Camarillo, CA 93012 - USA Richard Demers [email protected] +1(805) 373 4607 Cleared for public release by the DoD’s Office of Security Review, Case 13-S-1415

SPECIFICATIONS Input/Output Connectors Samtec ERF8-style connector (8 ROIC outputs) Micro-D 37-pin connector (4 or 8 ROIC outputs) Camera Link/ 2× 3M Shrunk Delta Ribbon connectors Camera Link Full pinout 4 channel: +5 VDC at 1.2 amp nominal, 2 amp maximum Power input 8 channel: +5 VDC at 1.7 amp nominal, 2 amp maximum Board dimensions Enclosure dimensions Full CameraLink Interface FPA Output 0 ADC data channel 0 CameraLink out (LVDS + OSERDES) Conv start DSUB System clock SCLK/SDIN/ SLATCH/SDOUT FPA Serial FPA Power Supplies Reset, Fsync, Valids, Clock Teledyne Imaging Sensors 5212 Verdugo Way...