5.4 Rapid locking nut
8Pages

ACCESSORIES FOR FORMWORK CONSTRUCTION 5.4. RAPID LOCKING NUT and accessories

RAPID LOCKING NUT AND ACCESSORIES GENERAL INFORMATION Your benefits at a glance: G Sensational savings on time – see for yourself! The two-part nut is simply pushed onto the anchoring bar Only one employee is needed for each locking point thanks to the rapid locking bar with its wing nut welded on This means that formwork assembly and stripping times can be greatly shortened With the appropriate wrench, low noise work is possible particularly at night construction sites and with 3 shift working times Every day on all sites wall- and supporting formwork is encased and stroken with formwork...

RAPID LOCKING NUT AND ACCESSORIES GENERAL INFORMATION This new development is even more interesting for construction companies, who will use their own staff more concentrated. Every employer can calculate if he has to tighten and loosen 1000 or 5000 tightening spots per year. With a possible saving of time up to 2 minutes per tightening spot a saving potential results, which cannot be neglected! So far 2 workmen are needed to close a tightening spot, who are tightening the wing nuts on both sides of the formwok at the same time. With the new ROBUSTA-Locking-Set several rationalization...

RAPID LOCKING NUT AND ACCESSORIES MOUNTING Easy and quick mounting: 1 Install Rapid Locking Bar with welded counter plate at the first formwork panel. After placing the second side of the wall formwork simply push the rapid locking nut over the bar until the counter plate touches the formwork – no screwing necessary! Lock to prevent the turning of the anchor bar: Cham touches the side of the formwork frame. Press the nut easily by hand by turning the rotating wrench. Simple tightening of the bar with a hammer because of the big lever arm of the wrench. rapid locking nut and accessories

RAPID LOCKING NUT AND ACCESSORIES STRIKING Easy and quick striking: 1 Open the nut with the Socket tool – careful, efficient and without noise. To unlock the enclosed 2 nut halves press the body of the rapid locking nut towards the formwork while holding back the two wings with the forefingers. After releasing the tension in the bar turn the nut by hand with 2 or 3 rotations to move it a little bit apart from the formwork. After that the rapid locking nut can be pushed over the bar, holding the wings simultaneously. The experienced user even manages to do this with one hand! Products...

RAPID LOCKING NUT AND ACCESSORIES SAVING IN FIGURES Calculation example for the quick amortization of the Rapid Locking Set A building contractor of an average size has approx. 300 m² wall formwork in his own stock, with approx. 20 uses per year. We are looking at a period of time of 5 years. 300 m2 x 20 uses/year x 5 years For the different wall casing systems result 0.8 – 1.2 anchors/m2 24.000 anchor points, which have to be opened and closed With different timing measurements we found out a time saving of 1,5 minutes per anchor point. Thus we achieved the following result: 24.000 anchor...

RAPID LOCKING NUT AND ACCESSORIES GENERAL INFORMATION TECHNICAL DATA: threa Rapid Locking Nut Weight [kg/unit] Rapid Locking Bar, consisting of tie bar D&W Ø 15 mm and welded counter plate with cham Length [mm] Weight [kg/unit] Rapid Locking Set, consisting of Rapid Locking Bar D&W 15 mm and rapid locking nut Length [mm] Weight [kg/unit] Socket tool fore noiseless work Length [mm] 710 Products subject to technical changes

Berlin office: Date of issue: January 2020