RTI Remote Docking Interface for Credence Diamond D10PRODUCT OVERVIEW Dl0-768. The RTI D10 Interface and DUT Fixture is designed to allow testing of devices remote from a Credence Diamond DIO test system. The RTI system is designed to be upgradeable from 96 to 768 channels, in increments of 96. All power supplies, sense lines, and most DIBU signals can be accessed at the remote DUT board. The DUT Fixture is designed to fit on probe stations, LSM, EMMI and other diagnostic tools. Interface to DUT cards (performance boards) are made through high-performance pogo pins. RTI's high-speed f coaxial ribbon cables mount directly on the bottom side of the pogo pins. All of the DIO's sixteen power supplies and most of the DIBU functions are also available at the DUT Fixture. RTI also supplies custom DUT cards and test sockets for the system. The DIO Interface Fixture plugs directly onto the DIO test system. All test channels maintain 50 ohm impedance throughout the system. RTI INTERFACE FIXTURE D10-768 The RTI D10 is 10"x12". It is field upgradeable from 96 to 768 pins in increments of 96 pins by adding additional D10 Pogo Blocks (D10-96PPB-IF) and cables (RTI-96HS-C). All Molex connectors required for up to 786-channel operation are pressed into the interface PCB in slots 0-9 DUT A and DUT B and slot 9 DUT C. Users can contact each signal pin on the DUT A and DUT B connectors for slot 0 through 9 using option Pogo Pin Access Blocks (D10-PP-ACCESS). Cables from Interface Fixture to Remote DUT Fixture ◊ There are provisions for up to eight Pogo Pin Blocks (D10-96PPB-IF) and eight RTI 96 Channel High Speed Coaxial Ribbon Cables (RTI-96HS-C) ◊ There are two Power Supply Cables (D10-PS-C) for all 16 power supplies and sense lines. ◊ There are two DIBU ribbon cables (D10-DIBU-C1 and D10-DIBU-C2 ) Additional Test Points on the Interface Fixture ◊ DUT A SCOPE_TP2 (8 total) (.100 headers) ◊ TP1 for each DPIN card (3V signal) used for pass/fail flags (8 test points total) are used to create a global pass / fail flag. ◊ DUT B SCOPE TP (TP3, TP4) (16 total test points) (.100 headers) ◊ DIBU DUT A (8) SCOPE_TP - (.100 headers) ◊ DIBU DUT A (8) GPIO pins - (.100 headers)

RTI Remote Docking Interface for Credence Diamond D10 RTI DUT FIXTURE D10-768-DF Physical Dimensions ◊ 9.5 inches x 9.5 inches by 2.1 inches high (not including height of alignment pins) General Specifications ◊ All connections to the DUT board are made through the pogo pin blocks, including up to 768 test channels, Sixteen D10 power supplies and references, and connections to the DIBU channels. ◊ The DUT Fixture is designed to fit on probe stations, LSM, EMMI and other remote diagnostic tools. ◊ The DUT Fixture is field upgradeable from 96 to 768 pins in increments of 96 by adding additional...