Catalog excerpts
Safety Distances for Safety Systems Reaching over edges on work or safety equipment When reaching over edges on equipment or safety mechanisms, the required safety distance is satisfied if the height of the dangerous area in mm (A) and the height of the protective structure in mm (B) are no less than the corresponding value in the table below for horizontal distance from the dangerous area in mm (C). This assumes that the protective structure has a height of over 1000 mm. The area between the safety structure and the dangerous area may not be entered. General safety distances Safety distances relative to human size must be taken into consideration when securing dangerous areas. These safety distances are based on the reach of a person (14 years or older) in the direction of the dangerous area with their own body parts and without the use of objects, then a safety margin is added. Opening width e Safety clearance Square 6 180 mm and square or round openings > 240 mm permit entry for the entire body. If there is a risk of slipping or abuse, the specified value may be unsuitable. Additional measures may be necessary to restrict access. hazard zone hazard zone Height of protective structure in mm (B) 2400 Horizontal distance from danger area in mm (C) 300 100 300 - Values for high risk
Open the catalog to page 1All ROBOTUNITS ITALIA SRL catalogs and technical brochures
-
THE MODULAR TOTE SYSTEM8 Pages
-
THE VERSATILE MBS PICKSTAR22 Pages
-
Fastener Loads1 Pages
-
Extrusion Tolerances2 Pages
-
MULTIFUNCTIONAL ACCESSORIES52 Pages
-
R5G1 Pages
-
R5F2 Pages
-
R5A1 Pages
-
R5D1 Pages
-
R5T01001 Pages
-
THE MODULAR TOTE SYSTEM8 Pages
