RIXOTACT_4
1 /2Pages

RIXOTACT_4

RIXOTACT_4
1 /2Pages

Catalog excerpts

RIXOTACT_4-1

RIXOTACT_4 Measuring draft, pressure and differential pressure + integrated Three-Point-Step-Controller + intergrated Transmitter 0-10V Measuring System "Ringbalance" measuring principle Display Pa, kPa, daPa, mbar, mmW.C., in.W.C. Measuring ranges from 0...40 Pa to 0...1.8 kPa (0.15"W.C. - 7"W.C.) and any range within these limits Measuring pick-up Hall - sensor (magnetic-field sensor) Accuracy Ambient temp. Polycarbonate light-grey, protection class IP65, Dimensions: 180 x 255 mm, 165 mm deep Controller Three-point-step-controller with PD action Setpoints W1/W2 two setpoints, adjustable from 20...80% of span, selectable via terminals 3-4 upper position: LCD shows the actual value "X" lower position: LCD shows actual setpoint "W" Control outputs potential-free relay contacts, rated at 250V/2A Control Settings P - proportional band, D - differential action, NZ - Neutral zone (deadband), F - switching (pulse-) frequency Transmitter Output signal 0-10 V, proportional to the measured (actual) value "X"; min.load: 2k ohms 230V AC (110/120/240 VAC; 24V DC); 3.5VA Electromagnetic Compatibility according to EN50081-2 (emmission) and EN50082-2 (immunity) Terminal Diagram Ordering specification 1. Type 2. Measuring range For best results, select such a range that your estimated setpoints lie approximately in the middle (mid-third) of the measuring range. 3. Power supply please specify Overload Protection Device "DZ" (Bypass) see next page Control output Setpoints W1/W2: open = W1 shorted = W2 Power supply

 Open the catalog to page 1
RIXOTACT_4-2

Measuring Ranges, Filling Fluids Overload Limits Measuring Ranges Filling Fluids Note: All Ringbalance instruments are factory-filled. The type of oil need not be mentioned in the order. Each instrument is calibrated individually, according to order. A factory calibration certificate is supplied to each unit. The ranges shown below are examples only. Any desired range between 40 Pa (0.15"W.C.) and 1.8 kPa (7"W.C.) is available. Examples: Pa Pa Pa Pa Pa Pa Pa Pa Pa Pa Pa Pa Pa Pa Pa Pa Pa Every Ringbalance is inherently protected to at least +/-900 Pa (3.5"W.C.), even it has, for example, a measuring...

 Open the catalog to page 2

All Rixen Messtechnik catalogs and technical brochures

  1. MU-Analog-65

    2  Pages

  2. MU Digital

    2  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.