LAMINATING AND GRANULATING EQUIPMENT Laminator and granulator for Research and Development, or small production batches. Minimum processing capacity of 0.5kg to 20kg. Manufactured under GMP regulations, this laminator and granulator has a tubular steel structure coated in hard chrome. It contains a loading hopper, an extrusion press (it extracts the air trapped within the powder), a grip area and cylinders (to laminate, cut, and granulate). It features a compact design in the isolated compression zone. Due to the simplicity in the front assembly construction design, rolls are quickly and easily changed. The size of the granules particles can be modified upon requirement, varying the cutting and granulating roll speeds, or replacing the size of the net. The PLC controls the start and stop algorithm in sequential mode for the three motors powered by the independent frequency adjusters. Parameters controlling both the motor speeds and the compression force of the rolls can be stored as files, with a maximum capacity for 99 products. The machine works on a single-phase power line, which is supplied with a hydraulic electro-pump to adjust the compression force from the control board. Technical Data Diameter of the Compacting Rolls Width of the Compacting Rolls Rotation Speed of the Rolls Maximum Pressure of the Hydraulic Pump Cooling Water Powder Processing Capacity Compression Force on the Cylinder Installed Power Riva S.A. Génova 4018 – B1702CQH Buenos Aires – Argentina TEL.: +54 11 4653-2000 Fax: +54 11 4653-3100 WWW.RIVASA.COM [email protected] Riva S.A. reserves the right to modify the features described due to technological improvements. All rights reserved.