RHV Series Vertical Storing Hydraulic Dock Levelers Engineered for safety, security, environmental control and the smoothest transition in the industry. Constant radius rear hinge Two-point crown control Maximum environmental control Overhead door closes all the way to the pit floor, providing environmental control over temperature and humidity. Smooth transition technology » Ensures smooth transition between loading dock and trailer with constant radius rear hinge, two-point crown control and optimized lip chamfer design features. » Reduces forklift operators exposure to whole body vibration which can lead to chronic back and neck injuries. » Minimizes product damage. Platform construction » Structural design incorporates no more than 8" (203 mm) of beam spacing under the deck to accommodate 3-wheel and 4-wheel forklift traffic. » Designed to flex up to 4" (102 mm) under its own weight to maintain a smooth transition for forklifts on out of balance trailers. » ANSI MH30.1 tested and certified. 360 Degree protection » Safe-T-Pit™ (patent pending) provides an additional layer of pedestrian protection that disables leveler operation when personnel movement is detected in the pit. » Constant-contact controls allow operator to extend lip or stop platform and lip at any time during leveler travel - keeping the operator in control at all times. » Leveler stores over-center, reducing pressure on the hydraulic system. » Acts as a barrier that protects against overhead door damage. Full-range free-float Mechanical counterbalance valve allows leveler to float when positioned in the trailer. Easy pit clean-out Vertical storing position and clean frame design allows for easy pit cleaning or full wash-down. Environmentally friendly Hydraulic fluid is biodegradable. RlTE'HfTE ALWAYS LOOKING AHEAD

SpecificationsNominal dimensions Widths Lengths *Consult Rite-Hite® for Drive-Through Application lengths. Operation Fully hydraulic. The movement of the level er ramp and lip is controlled electro-hydraulically from a NEMA 4X rated push-button station. Pushing a button on the control box shall lower and/or raise the unit. Constant pressure is required for ramp movement; ramp shall not lower by gravity alone. The lip can be extended at any time during the cycle from the push-button station; end-loading and below-dock end-loading position is obtained without recycling the leveler. Standard...