Cone Clamping Elements RLK 133 centres the hub to the shaft short axial width with fixed backstop point Features • Centres the hub to the shaft • Short axial width • No axial displacement between hub and shaft during clamping procedure due to fixed backstop point • Transmissible torque of 350 Nm up to 51 500 Nm • For shaft diameters between 20 mm and 200 mm Application example Backlash free connection of a timing belt pulley to the drive shaft with a Cone Clamping Element RLK 133. Due to the fixed backstop point, the timing belt pulley is not displaced axially during clamping. The Cone Clamping Element also centres the timing belt pulley to the shaft. The compact Cone Clamping Element is a cost- efficient solution especially for applications with low space requirements. Transmissible torques and axial forces The transmissible torques or axial forces listed on the following page are subject to the following tolerances, surface characteristics and material requirements. Please contact us in the case of deviations. Tolerances • h8 for shaft diameter d • H8 for hub bore D Simultaneous transmission of torque and axial force Surfaces Average surface roughness at the contact surfaces between the shaft and the hub bore: Rz = 10 … 25 µm. Materials The following apply to the shaft and the hub: • E-module ≥ 170 kN/mm2 The transmissible torques M which are shown in the tables apply for axial forces F = 0 kN and conversely, the indicated axial forces F apply to torques M = 0 Nm. If torque and axial force are to be t ransmitted s imultaneously, the transmissible torque and the transmissible axial force are reduced. Please refer to the technical points on pages 78 and 79. Please request our installation and operating instructions for Cone Clamping Elements RLK 133. Cone Clamping Element RLK 133 for shaft diameter d = 100 mm: • RLK 133, size 100 x 145

Cone Clamping Elements RLK 133 centres the hub to the shaft short axial width with fixed backstop point * maximum outside diamet