Complete Freewheels FB for bolting to the face with sprags, available in four types Application as ➧ Backstop ➧ Overrunning Clutch ➧ Indexing Freewheel Features Standard type, type with RIDUVIT® or sprag lift-off Z Complete Freewheels FB are sealed sprag freewheels with ball bearings. They are supplied oil-filled and ready for installation. In addition to the standard type, three other types are available for extended service life. Nominal torques up to 160 000 Nm. Bores up to 300 mm. A multitude of standardized bore diameters are available with short delivery times. Type with sprag lift-off X Application example Two Complete Freewheels FB 82 SFT as overrunning clutches in the drive of an edge trimming shear in a wide strip roll train. When trimming the edges of the strip, the trimming rollers are driven by the drive of the edge trimming shear. By doing so, the two freewheels work in driving operation. As soon as the sheet metal strip is gripped by the next pair of rollers, they pull the strip at an increased speed and the inner rings overrun the slower turning drive of the edge trimming shear. By doing so, the freewheels work in freewheeling operation. The RIDUVIT® sprags give the freewheels an extended service life. The customer attachment part is on the external diameter D and then bolted on to the face. The tolerance of the shaft must be ISO h6 or j6 and the tolerance of the pilot diameter D of the attachment part must be ISO H7 or J7. Freewheel size FB 72, type with sprag lift-off Z and 40 mm bore: • FB 72 LZ, d = 40 mm When ordering freewheel size FB 340 and FB 440, please also specify the freewheeling direction of the inner ring when viewed in direction X: • counterclockwise free or • clockwi

Complete Freewheels Standard type For universal use ■ Freewheels with bore diameters highlighted blue in the table are available with short delivery times. Keyway according to DIN 6885, page 1 ♦ Tolerance of keyway width JS10. * Keyway according to DIN 6885, page 3 ♦ Tolerance of keyway width JS10. ** Z = Number of tapped holes G on pitch circle T.