WWG
1Pages

Catalog excerpts

WATER ALARM UNIT WWG water alarm unit - principle conductivity • • • • Ideal for laundry rooms, cellars/storage rooms, pump and inspection ducts. With visual/audible alarms, Test and Acknowledge buttons and 2 relay outputs. With floor probe or wall mounting rail probe. A request with GSM system for event reporting. Application For visual and audible alarms in the event of accumulations of electrically conductive liquids such as rainwater, tap water, fresh water, waste water, cooling water and heating water. Tutti i dati ed i contenuti di questa scheda sono di proprietà esclusiva di Riels Instruments Description Alarm unit in wall mounting housing for the detection of even the smallest amounts of water caused by, for example, backflow due to clogged water pipes, water ingress from outdoors, broken pipes or failure of a waste water pump. WWG1 consists of a control unit with visual/audible alarm, Test and Acknowledge buttons, two relay outputs as well as a special floor probe. The probe is mounted at the lowest point of the object to be monitored. The alarm is triggered when the probe comes into contact with liquid. The audible alarm can be muted with the Acknowledge button. The visual alarm is cleared once the leak has been fixed.The Test button allows you to simulate an alarm condition in order to perform a function check. The two voltage-free relay contacts are provided for connection of additional external alarm equipment or alarm units. One relay can be acknowledged (e.g. for an external horn), the other relay cannot (e.g. for an external lamp, a solenoid valve, a pump). The alarm units are suitable for panel mounting with a mounting frame. A sealing kit (IP 54) is available for rough application conditions. Alarm units with the EnOcean-ready label can be integrated into your existing building automation systems at a later point in time. To do so, plug the EnOcean® wireless module into the EnOcean® interface (PCB of the device). Water alarm unit WWG2 like WWG1, but with height-adjustable wall mounting rail probe. Technical specifications Floor probe BWS 11 Wall mounting rail probe WSS Response level approx. 2–3 mm Dimensions Ø x L: 75x40 mm Height-adjustable by approx. 200 mm W x H x D: 37x320x55 mm Standard probe cables: Operating temperature range: Supply voltage: Nominal power: Switching output: 1 voltage-free changeover contact 1 voltage-free normally open contact (can be acknowledged) Contact rating: Alarm sound: Wall mounting housing made of impact-resistant plastic (ABS) W x H x D: 100x188x65 mm Degree of protection: IP 40 (EN 60529) Control unit Floor probe BWS 10 (for WWG 1) Wall mounting rail probe WWS (for WWG 2) EnOcean® wireless module (can be retrofitted)

Open the catalog to page 1

WWG 1Pages

Catalog excerpts

All Riels Instruments catalogs and technical brochures

WWG
1Pages