LEVEL CONTROLS Suitable for solid materials and materials with strong presences of powders 26 GHz Frequency Measurement Up to 70 meters. All data and contents of this board are the exclusive property of Riels Instruments It is suitable for applications in storage tanks, reactors and process vessels even under severe process conditions. Suitable for most applications involving bulk products, even in dusty environments and at high temperatures up to + 250°C Application for cement dust, powder materials and plastic granules, grain, coal, wood dust, fly ash. The antenna is optimized for various calculations, the new microprocessors have a greater speed and efficiency to perform signal analysis. They can be used for measurements in very difficult environments. Features of the 26GHz radar level transmitter • Easy to install; non-contact radar no wear no pollution, no corrosion, no bubble effect; not affected by water vapor in the atmosphere by temperature and pressure variations. • Simple calibration, accurated measure and speed of response. • High signal-to-noise ratio, the state level fluctuation get better performance. • Rugged steel construction for industrial applications • On request ATEX version for areas with risk of explosion. Application Solids with a strong presence of dust and crystallization Measuring Range up to 70 m Connection Threaded (flanged on request) Pressure Atmospheric Signal output 4^20 mA / HART 2 wires-4 wires Protection degree / EX IP67 / Atex Exia IIC T6 Ga on request Dimensions Riels Instruments Srl • +39 049 8961771 • +39 049 717368 • www.riels.it • [email protected]

LEVEL CONTROLS How to order the RIL410 A Measurement range B Minimum level C Maximum level D dead zone I Intrinsic safety (Exia IIC T6 Ga) Connections G Threaded G1" / A / Stainless steel AISI 304 N Filettato 1" / NPT Stainless steel AISI 304 B Flange DN80 /Stainless steel AISI 304 C Flange DN100 /Stainless steel AISI 304 M Flange DN80 / Carbon steel nikel plated K Flange DN100 / Carbon steel nikel plated T Flange DN125 / Carbon steel nikel plated Z Flange DN150 / Carbon steel nikel plated All data and contents of this board are the exclusive property of Riels Instruments...