*mydirectindustry

Catalogs
RHEINTACHO Messtechnik GmbH
Sensors: 1-Channel Differential-Hall M12-cable series

Sensors: 1-Channel Differential-Hall M12-cable series

Product catalog summary

Overview: The document provides a technical overview of the RHEINTACHO 1-Channel Differential-Hall M12 cable series speed sensor, which is designed for measuring, controlling, and indicating rotational speeds in vehicles, mobile machines, and hydraulic drives.

Specifications: The sensor operates with a power supply of 10 VDC to 30 VDC, with a maximum of 36 VDC for 1 minute. It supports a frequency range of 0.5 Hz to 20 kHz and functions within an operating temperature of -40°C to +125°C. It has a protection rating of IP67/IP69K and is housed in stainless steel 1.4305.

Features: Key features include detection capability up to 20,000 Hz, required alignment for installation, and a large air gap capability.

Electrical Specifications: The sensor consumes 20 mA at 24 VDC and 1000 Hz, with a maximum output current of 500 mA at 24 VDC and 25°C. It includes short circuit and reverse polarity protection, with output signal levels of Low ≤ 2 V and High ≥ Ub-2V.

Environmental Conditions: The sensor is resistant to vibrations from 10 Hz to 1000 Hz, shock resistance of 100 g at 6 ms, and temperature shock from +125°C to +20°C. It has a mean time to failure (MTTF) of 150 years at +100°C.

Safety Instructions: Installation and commissioning should be conducted by trained specialists. Ensure the machine is safe before commissioning, and replace any defective components immediately.

Installation Notes: Avoid installation near heat sources or radio systems, ensure cables are sealed against water ingress, and handle the sensor carefully to prevent damage.

Transport and Storage: Inspect for transport damage and report immediately. Do not use the sensor if dropped due to potential unseen damage.

Usage Guidelines: Operate within specified conditions to prevent hazards and damage. The sensor is not suitable for explosive environments.

Connection and Wiring Guidelines: Shield speed sensor lines, keep them short, and connect to the ground with low resistance. Avoid routing near power-conducting lines and ensure mechanical security of the cable harness.

Intended Use: The sensor should operate within specified voltage, temperature, vibration, and shock ranges. Use outside these conditions may pose risks or cause damage.

Improper Use: Use outside intended conditions is improper and voids warranty and liability claims. Use in explosive areas is prohibited.

Use in Safety-Related Functions: Customers must perform risk analysis and define safety functions. Implement measures like sensor redundancy and emergency switches in safety applications.

Disposal: Dispose of the speed sensor according to national regulations.

Catalog excerpts

Sensors: 1-Channel Differential-Hall M12-cable series-1

Drehzahlen sicher erfassen, anzeigen und kontrollieren For reliable measurement, control and indication of rotational speeds M12 Technisches Datenblatt / Technical Data Sheet Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz M12 Kabel-Baureihe / 1-Channel Differential-Hall M12 cable series Ausführung mit Stecker ebenfalls verfügbar; jedoch technisch abweichend und in separatem Datenblatt beschrieben. / Version with plug also available; but with technical differences and explained in separate datasheet. RHEINTACHO Messtechnik GmbH · Waltershofener Str. 1 · D-79111 Freiburg phone +49 761 4513 0 · fax +49 761 445274 · www.rheintacho.de

Open the catalog to page 1

Sensors: 1-Channel Differential-Hall M12-cable series-2

Technisches Datenblatt / Technical Data Sheet Data summary Power supply 10 VDC ... 30 VDC Anwendung ♦ Drehzahlerfassung an Zahnradern mit kleinem Modul und hoher Auflosung ♦ Anwendung in Fahrzeugen, mobilen Arbeitsmaschinen und hydraulischen Antrieben ♦ EinbaumaB M12 Merkmale ♦ Messungen bis 20.000 Hz ♦ Richtungsabhangiger Einbau ♦ GroBer Schaltabstand ♦ Edelstahl Applications ♦ Speed detection of gearwheels with small module and high resolution ♦ Applications in vehicles, mobile operating machines and hydraulic drives ♦ Installation dimension DIN M12 Features ♦ Detection up to 20,000 Hz ♦ Alignment...

Open the catalog to page 2

Sensors: 1-Channel Differential-Hall M12-cable series-3

Technisches Datenblatt / Technical Data Sheet Produktionscharge / Production lot Artikelnummer / Part number Produktkennzeichnung / Product marking Jahr Jahr Woche Woche Charge (Charge) auf Sensor, Stecker, Kabel oder Kabel-Clip (je nach Typ) / Year Year Week Week Lot (Lot) on sensor, plug, cable or cable-clip (depending on type) RHEINTACHO Artikelnummer gedruckt auf Sensor, Stecker, Kabel oder Kabel-Clip (je nach Typ) / RHEINTACHO part number printed on sensor, plug, cable or cable-clip (depending on type) RHEINTACHO Messtechnik GmbH • Waltershofener Str. 1 • D-79111 Freiburg phone +49 761 4513...

Open the catalog to page 3

Sensors: 1-Channel Differential-Hall M12-cable series-4

Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz M12 Kabel-Baureihe / 1-Channel Differential-Hall M12 cable series Technisches Datenblatt / Technical Data Sheet Einbau / Mounting Einbauart / Mounting principle Einschraubgewinde, richtungsabhängig / DIN type thread, alignment required Anzugsmoment / Tightening torque Biegeradius Anschlusskabel / Bending radius of connection cable Schalt- / Einbauabstand / Air gap 50 mm 0,2 mm ... 3,0 mm @ 1 kHz; M2 Basis: Evolventenverzahnung / Involute gear Maximaler Einbauabstand bezogen auf Modul und Arbeitsfrequenz / Maximum air gap related to module and...

Open the catalog to page 4

Sensors: 1-Channel Differential-Hall M12-cable series-5

Technisches Datenblatt / Technical Data Sheet Elektrische Daten / Electrical Specifications Anschlusse / Connections Kabel / Cable Anschlussbelegung Kabel / Cable terminal assignment 4 x 0,5 mm2, ungeschirmt, TPE, bestandig gegenuber Motoren- und Diesel- und Hydraulikol / 4 x 0.5 mm2, shielded, TPE, resistant against motoroil, diesel and hydraulic fluid Braun / Brown: VDC WeiG / White: nicht belegt / not connected Blau / Blue: Masse / Ground Schwarz / Black: Signal Prinzipschaltbild / Circuit diagram Anschlussschaltbild / Electrical connection RHEINTACHO Messtechnik GmbH • Waltershofener Str....

Open the catalog to page 5

Sensors: 1-Channel Differential-Hall M12-cable series-6

Technisches Datenblatt / Technical Data Sheet RHEINTACHO Messtechnik GmbH • Waltershofener Str. 1 • D-79111 Freiburg phone +49 761 4513 0 • fax +49 761 445274 • www.rheintacho.de

Open the catalog to page 6

Sensors: 1-Channel Differential-Hall M12-cable series-7

Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz M12 Kabel-Baureihe / 1-Channel Differential-Hall M12 cable series Technisches Datenblatt / Technical Data Sheet Zeichnungen / Drawings RHEINTACHO Messtechnik GmbH · Waltershofener Str. 1 · D-79111 Freiburg phone +49 761 4513 0 · fax +49 761 445274 · www.rheintacho.de

Open the catalog to page 7

Sensors: 1-Channel Differential-Hall M12-cable series-8

Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz M12 Kabel-Baureihe / 1-Channel Differential-Hall M12 cable series Technisches Datenblatt / Technical Data Sheet Sicherheitshinweise / Safety Instructions Allgemeine Hinweise General instructions Vor Festlegung Ihrer Konstruktion verbindliche Einbauzeichnung Before finalizing your design request a certified installation drawing. Any suggested circuits do not imply any technical liability for the system on Eventuelle Schaltungsvorschläge beinhalten keinerlei system- technische Verantwortung für die Anlage. Öffnen des Drehzahlsensors, Änderungen...

Open the catalog to page 8

Sensors: 1-Channel Differential-Hall M12-cable series-9

Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz M12 Kabel-Baureihe / 1-Channel Differential-Hall M12 cable series Technisches Datenblatt / Technical Data Sheet Hinweise zur Beschaltung und Leitungsführung Notes regarding the connection and the wiring Leitungen zu den Drehzahlsensoren sind so kurz wie möglich und Lines to the speed sensors are to be shielded and kept as short as possible geschirmt auszuführen. Die Abschirmung ist einseitig an der Elektronik oder niederohmig an der Geräte- bzw. Fahrzeugmasse anzuschließen. Der Drehzahlsensor sollte nur im spannungslosen Zustand gesteckt Die...

Open the catalog to page 9

Sensors: 1-Channel Differential-Hall M12-cable series-10

Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz M12 Kabel-Baureihe / 1-Channel Differential-Hall M12 cable series Technisches Datenblatt / Technical Data Sheet Einsatz in sicherheitsrelevanten Funktionen Es ist die Verantwortung des Kunden, eine Risikoanalyse seines The customer is responsible for performing risk analysis on the entire Gesamtsystems durchzuführen und die möglichen sicherheits- relevanten Funktionen zu bestimmen. Es ist die Verantwortung des Kunden, in sicherheitsrelevanten Anwendungen geeignete Maßnahmen zur Erreichung der Sicherheit zu ergreifen (Sensorredundanz, Plausibilitätsprüfung,...

Open the catalog to page 10

All RHEINTACHO Messtechnik GmbH catalogs and technical brochures

Archived catalogs

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list