- Catalogs
- RHEINTACHO Messtechnik GmbH
- Sensor: 1-Channel Differential-Hall FEhp high-pressure series
- Company
- Products
- Catalogs
- News & Trends
- Exhibitions
Sensor: 1-Channel Differential-Hall FEhp high-pressure series
Sensor: 1-Channel Differential-Hall FEhp high-pressure series
- Power Supply: SDN11 (4.5 VDC to 24 VDC), SDN12 (12.5 VDC to 32 VDC)
- Frequency Range: 0.1 Hz to 20 kHz
- Operating Temperature: -30°C to +125°C (-22°F to +257°F)
- Protection: IP67 / IP6K9K
- Output: NPN, open collector, without pull-up
- Current Consumption: < 30 mA @ 30 VDC
- Short Circuit Immunity and Reverse Polarity Protection: Yes, up to 50 mA
- High pressure resistance
- Compact size
- Directional mounting required
- Wide temperature and frequency range
- Requires symmetric flange mounting and careful handling to avoid sensor and O-ring damage.
- Recommended tightening torque for screws is 8 Nm ± 0.5 Nm.
- Cables should be routed away from heat sources and moving parts, and the sensor should be disconnected before welding or painting.
- Resistant to saltwater, hydraulic oils, diesel oils, and cleaning fluids.
- Dynamic pressure resistance: 210 bar (3046 psi), tested up to 280 bar (4061 psi).
- Static pressure resistance: 210 bar (3046 psi), tested up to 370 bar (5366 psi).
- Vibration and shock resistant according to EN standards.
- Installation and commissioning should be performed by trained specialists.
- Ensure no one is in the danger zone during commissioning.
- Complies with various EMC standards and has a long mean time to failure (MTTF) of 290 years at +100°C.
- Includes installation drawings and packaging details.
- Scope of delivery includes the sensor, O-ring, washers, and mounting instructions.
- Cables must not be routed near other power-conducting lines.
- Cable harness should be secured near the sensor installation area.
- Wires should be routed inside the vehicle or securely fixed if outside.
- Wires must not be kinked, twisted, or rub against edges.
- The sensor must operate within specified voltage, temperature, vibration, shock, and environmental conditions.
- Use outside these conditions may pose life risks or cause damage.
- Any use not described under "Intended Use" is improper.
- Use in explosive areas is prohibited.
- Improper use voids warranty and liability claims.
- Lines to sensors should be short and shielded, with the shield connected to electronics or ground.
- Sensor cables are sensitive to radiation interference and should be kept away from large electric machines.
- Sensor cables can be extended if signal requirements are met.
- Customers must perform risk analysis and define safety-related functions.
- Implement suitable safety measures like sensor redundancy and plausibility checks.
- Product data for safety assessment can be provided on request.
- The sensor must be disposed of according to national regulations.
Catalog excerpts
Drehzahlen sicher erfassen, anzeigen und kontrollieren >RHEIN^ For reliable measurement, control and indication of rotational speeds fTACHOr^ Technisches Datenblatt / Technical Data Sheet Drehzahlsensor / Speed Sensor 1 -Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1 -Channel Differential-Hall FE-hp high-pressure series RHEINTACHO Messtechnik GmbH • Waltershofener Str. 1 • D-79111 Freiburg
Open the catalog to page 1
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Betriebstemperatur, typisch Data summary Power supply SDN11 Frequency range Operation temperature, typically Drehzahlerfassung an Zahnrädern mit kleinem Modul und hoher Auflösung Speed detection of gearwheels with small module and high resolution Anwendung in Fahrzeugen, mobilen Arbeitsmaschinen, elektrischen und hydraulischen Antrieben mit hohen Drücken Applications in vehicles, mobile operating machines, electric...
Open the catalog to page 2
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Tauchtiefe / Insert. depth Anschluss / Connection 1,0 m Kabel ohne Stecker / 1.0 m cable without plug Ausgang / Output Stecker / Plug Lieferumfang / Scope of delivery ohne Stecker / without plug Sensor, O-Ring, 2 Unterlegscheiben, Montageanleitung / Sensor, O-ring, 2 washers, mounting instructions Verpackung / Packaging Einzelverpackung / Single packed Produktkennzeichnung / Product marking Produktionscharge / Production...
Open the catalog to page 3
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Einbau / Mounting Einbauart / Mounting principle Richtungsabhängig mit symmetrischem Flansch / Symmetric flange for directional dependence Anzugsmoment Befestigungsschraube / Tightening torque fixing screw Befestigungsschraube / Fixing screw Zylinderschraube / Cylinder screw: ISO 4762 - M5 x 16 Festigkeitsklasse 12.9 nach DIN EN ISO 898-1 / Property class 12.9 according to DIN EN ISO 898-1 Biegeradius Anschlusskabel...
Open the catalog to page 4
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Elektrische Daten / Electrical Specifications Versorgung / Power supply Stromaufnahme / Current consumption Frequenzbereich / Frequency range Strombelastbarkeit / Current load Kurzschlussfest / Short circuit immunity Ja, Ausgang gegen Masse; Ausgang gegen Versorgung (VDC) bis max. 50 mA / Yes, output against ground; output against power supply (VDC) max. 50 mA Verpolungsschutz Versorgungsleitungen / Reverse polarity...
Open the catalog to page 5
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Einsatzbedingungen / Environmental conditions Betriebstemperaturbereich, Sensor / Operating temperature range, sensor Spezifikation O-Ring / O-Ring specification NBR Shorehärte A 70: -30 °C ... +100 °C / NBR Shore hardness A 70: -22 °F ... +212 °F Medienbeständigkeit des Gehäuses / Environmental resistance of housing Schutzart / Degree of protection (EN 60529 / ISO 20653) Salzwasser und diverse Hydrauliköle, Dieselöle,...
Open the catalog to page 6
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Zeichnungen / Drawings 1 - Nicht im Lieferumfang enthalten / not included in scope of delivery. 2 - Im Lieferumfang enthalten / included in scope of delivery. RHEINTACHO Messtechnik GmbH · Waltershofener Str. 1 · D-79111 Freiburg phone +49 761 4513 0 · fax +49 761 445274 · www.rheintacho.de
Open the catalog to page 7
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Zeichnungen / Drawings Einbauzeichnung / Installation drawing 0 Allgemeine Rauheit von Oberflächen: Ra = 3,2 / General roughness of surfaces: Ra = 3.2 RHEINTACHO Messtechnik GmbH · Waltershofener Str. 1 · D-79111 Freiburg phone +49 761 4513 0 · fax +49 761 445274 · www.rheintacho.de
Open the catalog to page 8
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Sicherheitshinweise / Safety Instructions Allgemeine Hinweise General instructions Vor Festlegung Ihrer Konstruktion verbindliche Einbauzeichnung Before finalizing your design request a certified installation drawing. Any suggested circuits do not imply any technical liability for the system on Eventuelle Schaltungsvorschläge beinhalten keinerlei system- technische Verantwortung für die Anlage. Öffnen des Drehzahlsensors,...
Open the catalog to page 9
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Hinweise zur Beschaltung und Leitungsführung Notes regarding the connection and the wiring Leitungen zu den Drehzahlsensoren sind so kurz wie möglich und Lines to the speed sensors are to be shielded and kept as short as possible geschirmt auszuführen. Die Abschirmung ist einseitig an der Elektronik oder niederohmig an der Geräte- bzw. Fahrzeugmasse anzuschließen. Der Drehzahlsensor sollte nur im spannungslosen Zustand...
Open the catalog to page 10
Drehzahlsensor / Speed Sensor 1-Kanal Hall-Differenz FE-hp Hochdruck Baureihe / 1-Channel Differential-Hall FE-hp high-pressure series Technisches Datenblatt / Technical Data Sheet Einsatz in sicherheitsrelevanten Funktionen Es ist die Verantwortung des Kunden, eine Risikoanalyse seines The customer is responsible for performing risk analysis on the entire Gesamtsystems durchzuführen und die möglichen sicherheits- relevanten Funktionen zu bestimmen. Es ist die Verantwortung des Kunden, in sicherheitsrelevanten Anwendungen geeignete Maßnahmen zur Erreichung der Sicherheit zu ergreifen (Sensorredundanz,...
Open the catalog to page 11All RHEINTACHO Messtechnik GmbH catalogs and technical brochures
RT STROBE pocket rolux3 Pages
RT STROBE pocketLED LASER6 Pages
RT STROBE pocket LED6 Pages
ROTAS speed monitor2 Pages
RHEINTACHO Stroboscopes6 Pages
Speed sensors4 Pages
Sensor Targets4 Pages
Image Brochure RHEINTACHO4 Pages
Channel Hall M14 Heavy Duty6 Pages
LED band indicator 5846 Pages
RT STROBE 7000 LED2 Pages
RT STROBE 12000 LED2 Pages
Channel Hall Inch5 Pages
RT STROBE 3000 XENON2 Pages
RT STROBE 5000 XENON2 Pages
RT STROBE 3000 LED2 Pages
RT STROBE 5000 LED2 Pages
Direction detector 5751.0017 Pages
Hall sensors Zoll5 Pages
AC-DC power pack3 Pages
F/I F/U converter11 Pages
Electrical tachometers4 Pages
Mechanical Tachometers4 Pages
RT STROBE control2 Pages
Archived catalogs
Vision control systems6 Pages
Sensor: 2-Channel Hall FE series12 Pages
Product overview2 Pages
- Panel panel meter
- Analog indicator
- Illuminated indicator
- LED indicator
- Signal converter
- Rotational speed sensor
- Magnetic speed sensor
- Digital tachometer
- Handheld tachometer
- Non-contact tachometer
- Contact tachometer
- Hall effect speed sensor
- Non-contact speed sensor
- Speed indicator
- Portable stroboscope
- LED stroboscope
- Compact speed sensor
- Digital stroboscope
- IP67 speed sensor
- Speed switch