Catalogs >
Resensys >
Enhanced Axial Strain Gauge IoT Sensor

Enhanced Axial Strain Gauge IoT Sensor
4Pages

Catalog excerpts

Enhanced Axial Strain Gauge IoT Sensor - 1

Enhanced Axial Strain Gauge IoT Sensor Ultra-Low Power Precision Sensing & Wireless Communication Typical Applications Structural Health Monitoring (Airplanes, Bridges, Buildings, Cranes, Tunnels, Platforms, Machinery, etc.) Fatigue Analysis Bridge Load Tests Fracture Critical Monitoring Extreme Load Tests Detect Overweight Loads (e.g., dump trucks) Long lifetime: Solar powered and almost maintenance free A Stand-alone IoT Device: all-in-one device capable of sensing, collecting and uploading data to the remote server Easy mounting: Flange mount or adhesive tape Ingress Protection: IP68, weatherproof, and protection from rain, snow, and UV exposure Maintenance free: Self-powered by a solar panel. No battery replacement, calibration or post-installation maintenance is required

Open the catalog to page 1

Enhanced Axial Strain Gauge IoT Sensor - 2

that once installed, it is almost maintenance free. The whole product meets IP68 standard (completely weatherproof). As a result, it is an excellent choice for strain monitoring applications that require the sensors to be installed some outdoor places which are often hard to reach. The device needs a Nano SIM card with an active plan that supports 4G LTE and a good cellular coverage to periodically connect to a remote server and send all measured data through the cellular network. It is a completely stand-alone product and does not need any other intermediate device such as a gateway....

Open the catalog to page 2

Enhanced Axial Strain Gauge IoT Sensor - 3

Installation Wireless transceiver box comes with mounting flanges. It can be installed either with screws and anchors through the flange holes or with VHB adhesive tape (for steel and smooth surfaces). Wireless Transceiver Dimensions (in inch) Figure 1: Wireless transceiver dimensions for enhanced strain gauge IoT sensor. All dimensions are in inch. Email: info@resensys.com

Open the catalog to page 3

Enhanced Axial Strain Gauge IoT Sensor - 4

Strain Gauge Sensing Element Dimensions The strain gauge sensing element produces the strain analog signal through its cable after it gets the excitation signal from the wireless transmitter part. This sensor is self-adhesive and it is meant to be used on steel structures. All dimensions are in mm [inch]. Figure 2: Sensing element dimensions of enhanced strain gauge IoT sensor. All dimensions are in mm [inch]. Ordering Information Part Number 2 Channel steel strain gauge Email: info@resensys.com

Open the catalog to page 4