Series 40TL Tank Level Sensor
2Pages

{{requestButtons}}

Catalog excerpts

Series 40TL Tank Level Sensor - 1

Tank Level Sensor The Red Valve Tank Level Sensor is not affected by foaming, ice and other conditions that can cause errors in ultrasonic and capacitance level sensors. The Red Valve Tank Level Sensor uses a high sensitivity, solid state pressure transmitter that is completely isolated from the process fluid by an elastomer sleeve that transmits pressure through a fluid fill. Accurate, dependable level readings ± 2” Can be flushed or rodded clean without removing from tank or disassembly Full 360º pressure reading Integral LED display available Simple design The pressure transmitter is available to sense gauge pressure for vented tanks and differential pressure for pressurized tanks. It can easily be calibrated for process fluid density or specific gravity in any height of tank. The output signal is 4-20 mA. An integral LED display is available and can be calibrated in virtually any units, e.g. percentages, inches H20, etc. Available for both vented and pressurized tanks 4-20 mA output The elastomer diaphragm provides maximum surface area with minimum diameter allowing installation close to the bottom of the tank. The sensor can be “rodded” from the outside of the tank to the inside of the tank in the event of a severe blockage. Materials of Construction Body and Flanges Carbon steel, optional 316 stainless steel Elastomer Diaphragm Buna-N, EPDM, Viton®, food grade rubber L Fill Fluid Silicone oil SENSOR SIZE FLANGE SPECIFICATION ANSI B16.1 125 CLASS Red Valve Company, Inc. • 600 North Bell Avenue, Carnegie, PA 15106 • 412-279-0044 • FAX 412-279-7878 • www.redvalve.com

Open the catalog to page 1
Series 40TL Tank Level Sensor - 2

Series 40TL-M Tank Level Sensor The Red Valve Tank Level Sensor is not affected by foaming, ice and other conditions that can cause errors in ultrasonic and capacitance level sensors. The Red Valve Tank Level Sensor uses a high sensitivity, solid state pressure transmitter that is completely isolated from the process fluid by an elastomer sleeve that transmits pressure through a fluid fill. Accurate, dependable level readings ± 5cm Can be flushed or rodded clean without removing from tank or disassembly Full 360º pressure reading Integral LED display available Simple design The pressure...

Open the catalog to page 2

All Red Valve catalogs and technical brochures

  1. Series DX

    1 Pages

  2. Series 40

    1 Pages

  3. Series 48

    1 Pages

  4. Series 48W

    1 Pages

  5. Series 40W

    1 Pages

  6. Series 45

    1 Pages

  7. SL-53

    1 Pages

  8. SL-50

    1 Pages

  9. R-4 Reducers

    1 Pages

  10. J1-Wide Arch

    1 Pages

  11. J1

    4 Pages

  12. Rubber Pipe

    1 Pages

  13. 26F

    1 Pages

  14. megaflex

    1 Pages

  15. Type R

    1 Pages

Archived catalogs