TECHNICAL BROCHURE AQUAVAR PrcPok Water Products

Red Jacket Water Products Residential Water Systems FEATURES Simple, fast sizing and installation. Range curves and selection charts generated from actual R&D tests. Kits configured for 30 Hz minimum and 80 Hz maximum operation. Kits use matched water end and motor (see component chart). Wiring is as easy as standard three-wire control box: • L1, L2 and Ground in from power supply • Red, Yellow, Black and Ground out to motor Pressure is factory preset at 50 psi with simple, fast, field adjustability for higher pressures. Three phase output to motor reduces wire cost. Switch Input for connecting...

Red Jacket Water Products Residential Water Systems PROPAK PERFORMANCE RANGE AND COMPONENTS MODEL HP 12RP1020 at Best Efficiency Flow (GPM) TDH (ft) at Maximum Runout WE Motor Controller Flow (GPM) TDH (ft) Order pressure tank separately, not included in kit AQUAVAR SOLO™ CONTROLLER – FEATURES New, more versatile user interface board • Provides switch connection for optional pressure or level switch • New current limit settings for all new CentriPro motors • Dry well sensitivity switch • Low pressure cut-off protection • 5 or 20 PSI pressure drop restart switch • Transducer better protected from...

TOTAL DYNAMIC HEAD

TOTAL DYNAMIC HEAD

TOTAL DYNAMIC HEAD

TOTAL DYNAMIC HEAD

TOTAL DYNAMIC HEAD

TOTAL DYNAMIC HEAD

TOTAL DYNAMIC HEAD

⑥ Lengths in bold require 90ºC wire. Shading indicates 40º C maximum ambient. * Wire does not meet the N.E.C. ampacity requirement. The lengths in each of the Wire Sizing tables represent 100% of the allowable voltage drop when motor is running at full load. When sizing wire, the voltage drop of each wire segment must be included. The total must not exceed 100% of the allowable drop. Take for example a 1.5 HP motor with a distance from Service Entrance to Controller of 100' and 500' between the Controller and Motor. • Service Entrance to Controller (455' is from the S.E. to Controller chart)...

THREE PHASE, 4", MOTOR DATA Electrical Data, 60 Hertz, 3450 RPM, 4" Motors CentriPro # Diaphragm Tank Sizing and Pre-Set Pressure Recommendations: Diaphragm type (captive air) tanks are required on these systems. Table 1: Tank Sizing Selection Use Total Tank Volume, not drawdown volume, to select the proper tank size. The total tank volume should be approximately 20% of the pump’s maximum flow. For example, when using a 10 gpm pump the system requires a minimum 2 gallon (total volume) tank. The tank sizing recommendations are field proven to prevent objectionable pressure drops on start-up and...