Overview
A load cell or force sensor is a device that converts load or force into an electrical signal. The RLS Single-Point Compression Load Cell is specifically designed for applications such as weighing scales. It is crucial to select a load cell with a range appropriate for the maximum force, including transient forces, to avoid overloading.

Specifications
- Type: Strain gauge transducer
- Output: 2mV/V ±10%
- Excitation/Supply: 0 to 15V (acceptable), 10V (calibrated)
- Bridge Resistance: 350 Ohms
- Linearity Error: ±0.02% F.S.
- Hysteresis: ±0.02% F.S.
- Repeatability: ±0.02% F.S.
- Resolution: Infinite
- Temperature Coefficient (Zero): ±0.0014% F.S./°F
- Temperature Coefficient (Span): ±0.0014% F.S./°F
- Operating Temperature Range: -4°F to 140°F
- Compensated Temperature Range: 14°F to 104°F
- Ingress Protection: IP65
- Over-range Capacity: 50%
- Major Construction Material: Aluminium alloy
- Electrical Termination: 9.8ft integral cable

Dimensions and Models
The load cells are available in various models with different capacities ranging from 5kgf to 100kgf. All models share the same dimensions: 4.65'' x 2.50'' x 1.18'' with an M6 mounting thread.

Additional Information
RDP Electrosense provides high-quality, low-noise, and high-precision strain gauge amplifiers to complement these load cells. The company is located in Pottstown, PA, USA, and can be contacted via phone or email for further inquiries.

Note
Specifications are subject to change due to ongoing development, and any modifications may affect the equipment's specifications.