RESISTORS ♦CAPACITORS ♦COILS'* DELAY LINES HIGH VOLTAGE AND HIGH VALUE RESISTORS □ Resistance values up to 200TO (2x1014Q), tolerances to 1%! □ Voltage rating to 14KV. Pulse voltage to 50KV avail. □ Low noise & voltage coefficient □ Industry’s best TCR, as low as ±25ppm/°C SPECIAL MODIFICATIONS □ Screw terminations available □ Resistance tolerances to ±0.2%, matching to 0.1% □ Voltage or resistance ratios up to 1000 : 1±1.0% □ Increased power, voltage, and operating frequency levels World’s highest resistance range! RCD Type UHV resistors are suited for all high value applications from general purpose bleed chains to highest reliability X-ray systems and tWt amplifiers. RCD’s exclusive complex oxide film features state-of-the-art performance and extended life stability. The unique molecular structure of the resistive element offers exceptional insensitivity to high voltage and thermal shock. The protective insulation provides a high dielectric voltage, and insulation resistance. Series UHV3 is hermetically sealed in a glass or ceramic case, minimizing the effects of moisture or contamination. * Maximum DC or ACRMS working voltage determined by E =Vpr below the critical resistance value. Voltage rating is doubled in warm oil. Increased voltage ratings available. **increased range available. 1 Characteristics are typical for resistance range up to 1GQ , consult factory concerning higher values 2 Measured between 100V and 500V on values above 100M (tighter VC’s available) APPLICATION NOTES 1) Due to possible surface condensation, high voltages should not be applied in conditions of high humidity. The end caps of UHV1&2 are uninsulated and need to be mounted an adequate distance from conductors to ensure adequate isolation voltage. 2) Type UHV3 is coated with silicone to reduce condensation on the glass case and minimize shunt resistance. The coating must not be damaged or subjected to solvents; handle by terminations. UHV3 >100G are supplied with a guard band to minimize leakage current. 3) Resistance measurements on values over 1 Meg are made at 100V. 4) Resistors are available with screw terminations & tapped end caps to provide virtually any voltage or resistance value by combining in series. RESISTANCE CODE Option Codes assigned by RCD (leave blank if std) Resis. Code 1% Tol: 3 signif. figures & multiplier (1001=1KQ. 1004= 1MQ, 1006=100MQ, 1G00= 1GQ, 1T50 =1.5T, etc.) Resis. Code 2% - 10%: 2 signif. figures & multiplier (105= 1MQ, 107=100M, 1G5= 1.5GQ, 15T=15TQ). Refer to Resis. Code table Tolerance Code: K=10%, J=5%, G=2%, F=1%- Packaging: B =Bulk, T= Tape & Reel- Termination: W= Lead-free, Q= Tin/Lead (leave blank if either is acceptable) Resistance Value RCD Components Inc, 520 E. Industrial Park Dr, Manchester, NH, USA 03109 rcdcomponents.com Tel: 603-669-0054 Fax: 603-669-5455 Email:[email protected] FA061B Sale of this product is in accordance with GF-061. Specifications subject to change without notice.