• Housing: Aluminium
• Positioning: Vertical axis
• Cable Entry: Through PG 21 to connect rings to the clamp and brush-holders
• Brushes: 20 A copper-graphite or silver-graphite for signals, 30 A and 50 A blade or copper-graphite
• Executions: 6 to 15 rings for 20 A, 4 to 14 rings for 30 A, 4 to 10 rings for 50 A
• Standards: EN 60947-5-1, EN 60529, 2006/95/CE, 2004/108/CE, 2006/42/CE
• Marking: CE

• Nominal Voltage: 660 V AC/DC
• Nominal Current: 20 A, 30 A, 50 A
• Protection Degree: IP 55
• Max Rotating Speed: 30 revs/min
• Test Voltage: 2.5 kV
• Operating Temperature: -20°C to +60°C
• Availability: Mixed versions with 20 A/30 A/50 A rings, signal versions with gold or silver rings

The PRS slipring must be installed by qualified personnel following safety standards. Ensure power is off before cabling. Connections should follow the equipment's wiring scheme. After installation, verify all commands function correctly. Avoid prolonged exposure to oils and acids.

1. Attach the central pipe to a plate using locknuts, ensuring a central hole of Ø 48.5-52.5 mm.
2. Rotation is facilitated by Ø 10 mm pivots on the base, spaced 160 mm apart.
3. Connect cables to brushes through PG21, ensuring no interference with moving parts.
4. Check equipotential surfaces and ground connections.

Regular maintenance by qualified personnel using original parts is required. Replace defective parts promptly to ensure safety.

1. Disconnect power and allow internal parts to cool.
2. Remove the cover and check brushes for wear.
3. Clean copper-graphite dust with compressed air or a brush.
4. Check cable tightness and cover seal condition.
5. Replace the cover after maintenance.

Note: Warranty does not cover modified equipment. RAVIOLI is not responsible for damages from incorrect installation or use.