Technical Sheet Sliprings Type PMS Main Performances Housing In aluminium, suitable for installation in inside or outside area In vertical axis, with threaded pipe at the bottom Rings cabled with 2 m long cable Cable entry Inside the fastener pipe for the rings and through the PG21 cable entry for the brush holders 20 A or 50 A copper graphite / silver graphite for signals From 6 to 30 rings 20 A - mixed executions 20/50 A Electrical Features Nominal voltage Nominal current Protection degree Max rotating speed Test voltage Operating temperature Standard Types Type G PMS B6 G PMS B10 G PMS B16 G PMS B20 G PMS B26 G PMS B30 • Types with 50 A rings • Mixed executions with 50 A / 20 A rings • Absolut Encoder • Flat bottom version without housing pipe • Micro-switches application • Signal versions with gold or silver rings Ravioli S.p.A. Via Passo Pordoi, 4 - 20139 Milan, Italy Tel. +39 02 53.63.01 - Fax +39 02 53.63.05 E-mail: [email protected] - w

The PMS slipring has to be installed only by qualified personnel in compliance with current safety standards. Power to the machine must be switched off before carrying out cabling. Connections are to be made in compliance with the wiring scheme of the controlled equipment. After installation has been completed, the installer is required to check that all commands are working properly. Avoid prolonged contact with oils and acids when using the equipment, as these may damage the products. 1) Using the locknuts (Ref. 27), attach the central pipe (Ref. 12) to a minimum 3 mm thick plate with a central...