Technical Sheet Sliprings Type PMP Main Performances Housing Metallic Positioning Vertical axis, as illustrated here below Rings cabled with 2 m long cable Cable entry With single-pole wires connected to the rings and through two pipe unions 3/4” Gas to the brush-holders From 18 to 42 rings 20 A - mixed executions 20 A / 50 A Armonized rules EN 60947-5-1 EN 60529 2006/95/CE - 2004/108/CE - 2006/42/CE Directives Marking Electrical Features Nominal voltage Nominal current Protection degree Max rotating speed Test voltage Operating temperature Standard Types 20 A N° Rings Availability on demand: • Types with 50 A rings • Mixed executions with 20 A / 50 A rings • Signal versions with gold or silver rings Ravioli S.p.A. Via Passo Pordoi, 4 - 20139 Milan, Italy Tel. +39 02 53.63.01 - Fax +39 02 53.63.05 E-mail: [email protected] - www.raviolispa.com Accessories Availability on demand: • Mercotac • Absolute Encoder • Micro-switches application • On

The PMP slipring has to be installed only by qualified personnel in compliance with current safety standards. Power to the machine must be turned off before carrying out wiring. Connections are to be made in compliance with the wiring scheme of the controlled equipment. After installation has been completed, the installer is required to check that all commands are working properly. Avoid prolonged contact with oils and acids when using the equipment, as these may damage the products. 1) The main plate (Ref. 5) is made using two holes of Ø 10.5 mm situated on the plate itself at a distance of...