Housing Positioning Connections Cable entry Technical Sheet Sliprings Type RollerMain Performances In aluminium Vertical axis Rings cabled with 2 m long cable Inside the fastener pipe for the rings and through the side M20 cable entries for the brush holders Executions From 6 to 24 rings 10 A Marking CE Nominal voltage Nominal current Protection degree Max rotating speed Test voltage Operating temperature Accessories Availability on demand: • Absolute Encoder • Passages for air Ravioli S.p.A. Via Passo Pordoi, 4 - 20139 Milano Tel. +39 02 53.63.01 - Fax +39 02 53.63.05 E-mail: [email protected] - www.raviolispa.com

The ROLLER slipring has to be installed only by qualified personnel in compliance with current safety standards. Power to the machine must be switched off before carrying out cabling. Connections are to be made in compliance with the wiring scheme of the controlled equipment. After installation has been completed, the installer is required to check that all commands are working properly. Avoid prolonged contact with oils and acids when using the equipment, as these may damage the products. 1) Using the locknuts (Ref. 27), attach the central pipe (Ref. 12) to a minimum 3 mm thick plate with a...