RMC SL
2Pages

Catalog excerpts

RMC SL San Giorgio di Nogaro (UD) - Italy Machining centre RMC SL is the most stable CNC machining center with movable carriage of its category. It is the machine which better satisfies the most demanding requests of firms processing extrusions. The axis are fully interpolating and therefore allow optimal finishing and far above the average working speed. It is available with 4 or 5 controlled axis, it is fully automatic and it performs drilling, milling and rigid tapping. The machine is available in three standard versions according to the X axis travelling capacity: 4.400-6.700-9.000 mm. The working area can be used exploiting the full length of the center (single zone mode) or two independent zones. The RMC SL center is equipped with a remote assistance system on IP network. Automatic length measurement

Open the catalog to page 1

RMC SLMachining center Clamps Electrospindle Tool magazine Strokes CNC Control The number of clamps depends on the length of the center and on the processing needs. Their positioning is executed by the movable carriage, their height can be set from the control console. The clamps travel along the entire X axis if the center works in single zone mood. The independent closing of the clamps can be controlled during the charge of the parts. The 12 kW S6 electrospindle with high torque allows the execution of hard processing which are typical of the industry. The spindle is cooled...

Open the catalog to page 2